Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
I found strange slowdown in SEGGER_RTT_printf() output which I use for reporting RSSI value at t BLE_GAP_EVT_RSSI_CHANGED event.
My sample code for nRF52832 is based on...
Hello,
I am using two nrf52840 DK boards, I tried to run TWI scanner example on one of the boards of SDK 15.0 example. I'm not getting the other device address it is giving...
Hello,
I'm working on a new project I just got passed on to me, and I just realized that the project uses indications instead of notifications for no good reason.
Then...
Hi all,
I'm testing serial_uartes example (from SDK v.15.3.0) on nRF52840 in order to adapt it to my own project.
I need to receive and send large amount of data (up to...
I am trying to add DFU service to my custom application, I have taken ble_app_hrs_s132 with DFU as a reference and added all the required files and made required changes in...
I have a Dongle and the Voltage of VDD OUT pin measures 0 VOlts usin multimeter and SEGGER j-link EDU (Results below)
it the chip (or the regulator on-chip) destroyed...
Hi,
I want to add mqtt to at_client sample. I tried to merge the files but I need to add few projects becuase there is dependencies..
I didn't find a way to add new dependencies...
Dear,
I have nRF9160 DK, and I tried to control SW5 to debug/programme for nRF91 or nRF52.
I could programme for nRF91, but I couldnt do it for nRF52, for example, Im...
I've tried the light switch example and it works pretty well. I want to make all the devices with the same model, so how can I send message from client to client?
A general question about the radio CRC registers: The CRCPOLY register is 24 bits wide, which can be used to specify a 24-bit polynomial, suitable for calculation a 23 bit...
Hello Everyone,
I need to turn off the bluetooth advertising on certain event/interrupt and start advertising again on another event/interrupt.
I have gone through the...
Have a nice day! We are working on a project where goal is to build up mesh-network up to 50 nodes with high sum data rate to up 100kbps through the node. For this purposes...
