Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Hi,
We are trying to use PPK2 to measure current of our board, we want to receive the data from PPK2 and parse by our owner python script, so could you provide the protocol...
Reading The adhoc smart waste solution uses the nRF9160 SiP I tried to reproduce the mention 6 µA with LTE-M in eDRX with an interval of 655 s.
I use
CONFIG_LTE_EDRX_REQ_VALUE_LTE_M...
Hi,
We use PPK2 very conveniently as a logger for testing.
How about adding the supply voltage as display options also?
We hope you will consider this.
Thank you...
Hi dear,
It is possible to establish parallels multi connection to different J-LINK's devices serial numbers via nrfjprog.dll, or any other automated way ?
We successfully...
Hello, I'm making a breakout board with nrf52832 qfaa. I used chip antenna (2450AT18B100E) and followed Nordic reference layout. I am getting around 60m range in an open environment...
run nrf Connect for bluetooth Low Energy Standalone
connect PCA10040 board
select "server setup"
press "+ New service" which adds a New Service
press "> New Service...
Hi, I am currently learning to retrieve location using thingy 91 and location example from nrf SDK. When I run it, I got this message (below).
After doing some research...
I want to change the data in the registers of Radio peripheral when the Radio at the state of "Disabled",but with no respons.
Only if I repower the Radio it works,but why...
Hi all !!!
I am trying to program the bootloader and softdevice using the J-Flash software, but I get this error, how can I fix it?
Board: PCA10056 (NRF52840)
SDK: 17...
Hello,
I'm currently using the nrf9160 for a university project and I'm having problems with connecting my custom PCB with nrf9160 to nRF Cloud using the asset-tracker-v2...
Hello:
I want to ask you, we want to add our own custom data in the Ble scan response package, including Company ID,
we know Nordic's company Id is 0x59, can we change...
Hello,
I am trying to connect the nrf9160 dk with the SLM application to our STM32.
The idea is to use the nrf9160 modem to connect to NB-IoT/LTE-M and control the modem...
Hi there,
I compiled a QSPI test program on board nrf52840dk. The SDK version is 1.9.1. Everything works fine. I would like to upgrade with SDK 2.2.x but I have several...
Hi Nordic.
I am developing with nRF52832DK and SDK 17.1.0
And it's connected with my Qualcomm board.
I want check GPIO input interrupt and output settings.
But...
