Hi,
I am currently testing the dect_shell example on two nRF9151 DKs and achieved a range of ~500m. I want to transition this setup into a multi-hop mesh network topology...
Hi: The device shows successful reconnection, but the mobile end is not connected.
And the connection information displayed on the device is (public), which is actually...
I am trying to measure the 300mA system current.
I cut off the system lane and connected Vin, Vout.
And when in ampere mode, the system is not turning ON.
(When I replaced...
Hi Nordic,
I have a custom board using a Raytac MDBT53 module with nRF5340. The board is designed for 3.3 V / LDO mode, but during bring-up I likely flashed firmware/configuration...
Hello Nordic support,
I am using two nRF54L15 devices with NCS v3.0.1 and ESB DPL at 1 Mbps. Auto ACK is enabled, the payload is 252 bytes, and the retransmit count is 9...
# SoftDevice Controller assert during DTM receiver test at dead/marginal RF link (nRF52833) ## Summary On an nRF52833, running the nRF Connect SDK Direct Test Mode (DTM) 2...
A customer implemented a nRF52840 (QIAA package) and says the output power is about 10dB lower than expected. Having done multiple nRF52 designs with good results, I reviewed...
Greetings,
I want to write the nRF Connect SDK v2.0.0 sample "nrf9160/https_client" to the nRF9160-DK, but when I use "Flash" in Visual Studio Code, the following error...
Hi,
I'm designing a drone based on these three Nordic IC:
nPM1100
nRF5340
nRF21540
Let's Start with nPM1100:
Based on this Reference circuitry
I based my...
On SDK 2.0.2, I was able to load peripheral_uart with CONFIG_BOOTLOADER_MCUBOOT=y and successfully update both the app core and net core using the thingy53. However when moving...
Hey,
I bought a device which uses the N52832 SoC, Im gonna attach a photo of the device. Is it possible to get the code from the device, modify it and then upload it to...
Do you know of any way of reading the installed modem version of an un-locked nrf9160 through the j-link programmer. I would like to conditionally program the modem firmware...
Hello ,
I want to use OLED display having SSD1351 driver with nRF52832 DK board over SPI. Is there any library or support available ? Please help to share if it is available...
Hi,
We have a peripheral based on the nRF52840 which connects to a smartphone as the central.
Following the guidelines for iOS we have selected a connection interval of...
Hello Devs,
I am testing an nRF52840, configured to operate to 1.8V using the DCDC converter. All pins are supposed to operate in a 0-1.8V range.
So my question is...
Using 52840, I would like to drive an external device at 800Khz
Works well without enabling the SoftDevice
But once the SD is enabled - this does not work
Ideas?
I used 9160 to develop a product for the customer. Previously, I used ncs1.2.0 SDK, and the power consumption of the whole machine was about 200uA. Now I am going to use ncs1...
Hi mate,
I followed the link (+) Add DFU support to your application - Software - nRF Connect SDK guides - Nordic DevZone (nordicsemi.com) step by step and its worked...
Hi mate,
I followed (+) Add DFU support to your application - Software - nRF Connect SDK guides - Nordic DevZone (nordicsemi.com) your instructions and successfully implemented...
