I am currently creating and testing a custom board equipped with the nRF9160 and the P822601 antenna. Considering future development, it is expected that another external...
Title: nRF54L05 issue after migrating from NCS 3.0.0 to NCS 3.3.0 with PM static partitions and MCUboot external-flash secondary slot Description: I am migrating a project...
I am currently designing a custom board for my nRF54L15 project and I would like to know if the "Antenna" pin on the nRF54L15 can have a DC path to ground/ground layer of...
I have a nRF54l15dk development board and a custom nRF54L15 board that I am trying to load a Matter Template sample application on. I have created a custom board device tree...
I have observed that when using the ESB protocol at maximum throughput, the measured power consumption decreases as the PHY data rate increases: 4 Mbps consumes less power...
Subject: Connecting LPCOMP CROSS event to TWO DPPI-driven tasks (GPIOTE toggle + TIMER count) simultaneously — only the last-configured one fires
Chip: nRF54L15 SDK: nRF...
Dear Nordic, i have started my application with toolchain & sdk both v3.3.0, using custom services & charachteristics, with BLE advertising @500ms interval works fine. but...
Hi,
I am using version S140 of an nRF52840 in an application that creates an extended (S=8) advertising beacon. For my application to comply with regulations, I need to...
On iOS 18 beta we faced a random issue: creating CBCentralManager doesn't trigger BLE permission dialog. There is a thread about this on Apple forums .
Freshly installed...
Dear support team, I see that the mater/Template (Release) example only needs 715K of memory, as shown below:
I want to use nrf54l15pdk/nrf54l15/cpuapp to compile a firmware...
I am experiencing an issue to reach the ADC Max value(4200mV) on the nRF5340(our custom board) . We are using a 12-bit ADC, 4.2V and received a reading of 3297 mV, but we...
Well, this one took me many hours of tracing to track down the root cause, so I hope it helps someone!
Note: I wasn't able to reproduce this directly with a sample included...
I'm trying to debug on the Thingy:53 platform using an Nordic DK as the J-Link intermediate. However, with NCS 2.6.1, adding ` CONFIG_DEBUG=y` to the project configuration...
I am programming with the nRF52840DKs. [Toolchain Manager: v1.3.0, IDE: Visual Studio Code (VSCode), SDK: ncs v2.6.0, window11 pro]
I am currently working on integrating...
Hello,
I am using the nPM1300 in my hardware design along the nRF52840 and a battery from Renata (ICP622540PMT) . All the power outputs of the nPM1300 are in use (LDO1...
Hi! We are currently in the process of migrating our nrf5 SDK code to NCS, on nrf52833-based hardware. After being stuck for a while on the basic init process of MCUBoot,...
Hi everyone, I haven't found any discussions on this topic yet. I'm trying to flash my nRF52840 custom board, which I bought on AliExpress. It's named "nRF52840 SuperMini...
Hello ,
Is it possible to possible change/disable the BLE services at runtime in zephyr ?
For eg. we have services A,B and C in normal operation and we want disable...
I'm having 3 issues with I2C: A) It keeps returning -5 (-EIO), failed to write to I2C device..., however I do sometimes see the byte going out so I'm not sure why it always...
