I am trying to make a product with NRF8002B. I finally have the product prototyped. The user will connect to the device, beep, light up, and track. It will always stay on...
Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I have an NRF24LE1 transmitter using ESB. It is sending a static payload of 10 bytes every sec.
The other configurations on the transmitter are: RF channel:2, CRC: 1 byte...
Hi,
i'm wondering if there is any IC (for example nRF52832) that can reach a range up to 155 meters available within the Nordic semiconductor catalog ?
i know that the...
In nRF5 SDK 12.1.0 a bug was fixed in nrf_drv_wdt_init(). Watchdog timeout could not be larger than 131 seconds because of (x * 32768) multiplication before. This bug is again...
In the spec it says that the typical ramp up time is 140us (or 40us in fast mode). But there is no details on maximum or minimum. What is the true tolerance on this value...
We are building a simple project, let 51822 connect the mobile, once per second. We found that the Tx power of 51822 is getting weaker and weaker (view the voltage over a...
I have a nrf51 dongle and would like to use PWM on 3 pins.
Managed to get it working on pins 15 and 16, but somehow pins from 17 to 20 just don't work.
For example: I set...
Hi,
I have two nrf52840 boards and I am using the ble_app_att_mtu_throughput test app. The tests seem to be working OK, but I am not getting the throughput I was expecting...
When performing flash operations, i.e. via FDS or FSTORAGE, etc. - will GPIOTE events be captured and 'queued' until the CPU is no longer halted?
Said another way:
Can...
Hi ,all
I have a problem in my project .I want to use gzp preload ack feature .When the host receives datas ,I would use this function "void gzp_preload_ack(uint8_t* src...
Hi,
I've asked a few questions previously regarding programming of the nRF24L01/+ for simple data interchange between two devices, and my questions were answered -- many...
I want to use the development kit for Bluetooth 5.0 IoT product development.
Is there packet sniffer software available for the nRF52840 development kit?
If yes, will...
hi,
I used gpiote to capture an external interrupt when I found an anomaly.
I configured the interrupt input io, burn the program can be normal operation, when...
Hello everyone,
I tried to connect with nrf51 with andriod 5.x .On connection indication the Master (android ) shows the following values of connection parameter (taken...
