Hi Team,
Is it possible to implement the iOS application to track the iBeacon Component after closing the application(Background processing).
Please provide any example...
Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
Hi there,
Can we please get an updated example for Appendix 5 in this blog ?
Specifically the DFUMaster_SPI and the bootloader_secure_SPIS. Ideally it would be compatible...
Hi!
I was trying the throughput example using two nRF5340PDK boards and I observed the throughput is very low, i.e. 1kpbs. I tried programming the cpuappns, but it didn...
Hello! Reading the following segment regarding Buttonless DFU with bonds from the documentation, I'm not clear as to the meaning of these paragraphs. It looks like two contradicting...
Hi
i am able to work with adc 0 for nrf9160 custom borad now i want to use adc 5 to adc 7 simultanuously can you please guide me to settings which i need to modify or a...
Hii guys ,
I am trying to pair two nrf52 bluetooth devices. How can we pair two stand alone nrf52 devices to send and receive data? Is there any example code to show such...
Hello community!
I have curious problems with the bootloading process in SDK 17.0.2 . What I am trying to do is the following:
1. Create a bootloader settings page with...
Hi there!
We are using nRF52840DK development kit with nRF-Connect SDK to build a pre-production version of our product.
We need more GPIO configurations for our project...
Hello Nordic, I am currently trying to develop an application that would send data via satellite if there is no LTE coverage but I don't see any relevant documentation regarding...
I am currently using the ble_app_template code from examples\ble_peripheral in SDK v10. The code and BLE read/write function successfully works. I now want to combine the...
When I publish messages to the mesh network via a Vendor Model, after connecting to device and performing a successful vendor command sequence, I start sending publishes of...
Helo, I am developing a BLE product, and @ encryption stage, I get thie message on the topic.
I attach my log for further information.
The log entry that gives the...
Hi. I am currently using an nRF52840 DK board and SDK 17.0.2.
I require 16-bit heart rate service UUID to work with a 128-bit vendor specified custom service.
When I create...
I have competed development on a project using the digikey sparkfun dev modules. I'm now entering production but my factory can not find a model on the market that works....
