Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
Hello,
So I am trying to build the ble_app_blinky_c example of SDK_14.2 to work for nRF52810 but encountered problems.
I used s132 v 5.1 for my softdevice by following...
Hi,
We have a project want to fixed "access address".
We want to fixed "access address" in every BLE connection (52840 as master)
Do you have some of API to assign ...
Hello, i made my own working NRF24L01+ using the reference design from the datasheet and it worked quite well. But i needed some more range so i wanted to add PA+LNA module...
[Google Translated]
Good day. I am new to application development. At the moment, I managed to implement a connection to nRF52832 using BLE via UART on an Android device...
Hi,
Greetings !
I want to take continuous 40 reading of adc by varying time interval between readings based on RPM value. I want timer interval resolution from 6 Sec...
Hi,
We are using nRF52840 on our product. Since we want to support USB function, we connected VBUS pin of the chipset directly to the USB connector.
We would like to know...
Hello there,
How can I activate long range (coded PHY) in IoT examples, especially in TCP Client application. I've searched that forum and all of entries discussing about...
After receiving my Thingy:91, all was working as expected until I found that the included 10MB of data on the iBasis SIM had been used up and the device refused to connect...
Using the nrf52840 for analog sensor measurements we wanted to increase the accuracy by doing a regular calibration. Doing so we sometimes noticed spurious changes in measurement...
Hi,
I am currently working on a project that requires the control of a BLDC and i am new to the nRF microcontroller is there anyone how can give me some sort of guide and...
Hi all,
i'm testing a feature of my project using the ble_app_blinky central example adapted for the nRF52840 dongle. My goal is to discover the devices that are advertising...
Hello All,
I am working on the development of a product based on the nFR52840 SoC (SDK 16 and softdevice 14) and have several pheripherals connected to the chip, one of...
