Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hello,
I am testing 9 channels for PER (1,2,3,21,22,23,37,38,39). During testing the last 3 channels I always get a single time out error in response to LE_TEST_END. I...
I am having quite a frustrating time trying to make SPI drivers compile into a 52811 project I already started, so I thought I'd back off, and try to just get an SPI example...
Tried to flash ncp .hex for pca10059 on a brand new dongle and now it is stuck in dfu (pulsing red led). The process worked on a second dongle without any issues.
Something...
Running nrfconnect320x8664.AppImage on Linux (SuSE Leap 15.1). Read "Getting Started" but that was of little help!
So, following my nose.. On the Apps tab of application...
HELLO,
I am trying to generate a 125kHz pwm siginal using nrf51802（sdk version12.3）. I use the oscilloscope to observe the wave form.I change the macro value of PERIOD_IN_US...
Hi,
I am developing an app for PCA10059 board. my app works well but after sometime and saving some data on flash, boards keep resetting and did not booted(LD1 blinking...
Does anyone have experience in porting both embedded and android code from the 13.1.0 SDK to 15.x.x?
I'm running into an issue where the system worked fine on 13.1.0,...
Hi,
I am actually tring to migrate a project from Keil to Segger Embedded Studio (SES) and i have a problem with the build of my project when tring to build ecc.c.
The...
Hi,
I have to nrf52832 , s132 modules working as peripheral and central.
I would like to get an idea and input on how to change central mode to peripheral mode.
The...
Hello everyone,
I am having some trouble starting the HFXO crystal manually before using the RADIO to send raw advertisements: the HFCLKSTARTED event never raises. The code...
Hi
I am relatively new to this software and I am using this for a project which involves device-device and user-device communication.I came across the ble relay example...
I have a question about "SEGGER Embedded Studio for ARM V4.12".
When "Build Solution" is executed, "Build failed" is displayed and an error occurs. However, if you do "Bulid...
