Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
why use 50ms and 400ms connection interval for testing the maximum data throughput(2M,247byte payload)?
Because 50ms can only send a pdu , and 400ms can send up to 8 pdu...
When I call this function on any of the Development Kits, my application restarts just like when I power up the DK for the first time (after being programmed of course) or...
Hi!
I'm trying to make the NFC feature on a custom board while having BLE (soft device). When I run the nfc record_text exemple project on my custom board, everything works...
We plan to design a module that wirelessly connects via the nRF52833 chip with RF amplification, 2 PWM outputs and multiple
Digital I/O interfaces，One ADC interface and...
I have developed the application code for light node in ble mesh network.
I was able to see this error quite often:
app_error_weak.c, 115, Mesh error 4 at 0x00000000 ...
Does the 9160 GPS module have a built-in LNA? Is it possible to adjust the GPS receiving sensitivity?
We hope that the wireless index of wearable products when worn on the...
The set up which are used are a nRF52840 dongle programmed through nRF52832DK's debugger. After executing "erase all" in Programmer app, which erased the bootloader, it's...
We are using NRF52832 based Module in our design. Currently BLE Services & characteristics used in our firmware: 1. Custom Service characteristic 1: 37 Bytes characteristic...
Hi,
I understand that BLE Logical Link Control and Adaptation Layer Protocol is responsible for protocol multiplexing capability.
Can you please explain what kind of protocol...
Hey,
when i call:
otLinkSetChannel(OTInstance, ThreadChannelToUse);
from the very beginning of the programm:
void main(void) { int ret; ret = InitLEDs(); InitTemperatureMeasurement...
We are using nrf5340-dk to communicate with nrf5340 custom board and trying to search for the other sensors' addresses. There is secure mode and unsecure mode CPU. Which mode...
Hi.
My first attempt to get SAADC to work was:
NRF_SAADC->INTENSET = (SAADC_INTEN_RESULTDONE_Enabled << SAADC_INTEN_RESULTDONE_Pos) | //A result is ready to get transferred...
