In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi,
I want to use a single firmware to be flashed on two devices that can be used as a ble peripheral with DK Button 3 and as a central with DK Button 4 .
I chose ble_app_multirole_lesc...
Hi guys,
i am using nrf52840 controller.
and in that i have mbe at 0x0000000 location.
i have two bootloader stage. that boot1 and boot 2.
boot 1 i am using to validate...
I have gotten the FDS_ERR_NO_PAGES issue multiple times now. In our last pre-production run, it randomly happened to a few units (4 out of 60). For 3 of the units, the error...
Hello everybody, i succeeded to get the output from BME280 and MPU6060 sensors I need to merge them together
Kindly, I need help to Setup prj.conf file
Thanks & Regar...
Hi Team
The max value of IOH and IOL is the total current of all GPIO, or It is the value for each of GPIO pin？
I have read the post https://devzone.nordicsemi.com/f/nordic...
I used 9160 to develop a project for the customer. According to my design, an apn needs to be set before connecting to the NB-iot network. However, when I used at command...
I wrote a bootloader code. The flash space range of bootloader is 0x27000-0x3b000, and the flash space of app is 0x3b000-0x80000, but the app doesn't work. What's the problem...
Hi, I am trying to implement a Data Logger using nRF52832. I am using a Temperature Sensor to get the Temp readings(logs) and a Flash Memory to store those logs. The data...
I tested the Android nRF UART app. Now I'd like to test the same on Windows. If the source code is there, the better. If it is in C ++ even better.
Can someone give me a...
I am at the prototyping phase.
My nRF52 device discovers services on the phone (like Current Time Service, Battery Service, Apple Notification Service, etc…).
I want to...
Hello, I would like to collect GPS and sensor data from the Nordic thingy91 module, then send them to the influxDB cloud without going through nrf Cloud, because nrf Cloud...
hi,
I have a question about the communication between nRF24LE1 and nrf51802.They communicate using the Gazell protocol,Can you help me solve this problem？
1.The communication...
