We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi, I'm implementing the DFU for the nRF5340 MCU and now need to set my private keys to be able to sign firmware files.
The issue is related to the Signature key file specification...
Hi,
The nrf connect for desktop extension in VS code is not loading anything under welcome, when I try to open the documentation or any other nrf related command it says...
Hello Nordic Engineer,
I tested the mesh functionality with one phone and the 52840 DK, and the DK is running the official mesh_light example. It worked successfully,...
Hi
I have a fully functional addressable LED driver interface using I2S + app_timer. This code has been functional for a long time by itself.
I just added the SAADC example...
First to contextualize my situation, I am in Brazil, more specifically in the city of São Paulo. When the development kit arrived, I immediately did the recommended initialization...
I am trying to send data from icm20948 sensor from the sensor node to the observer node using ble mesh. Due to the data from icm20948 is too large (9 uint16_t, 18bytes) for...
Hi Nordic community, I have received nRF7002DK device and trying to make it work on v2.9.0 sdk. I'm working wifi sample project,successfully building and flashing in the device...
I have installed the nRF Connect SDK, with both the toolchain and SDK set to version V2.9. I selected the nrf54l15dk board for development, but I do not have a physical nrf54l15dk...
Hello ,
I have taken reference project which use all leads and buttons of Evaluation module NRF52833.
I want to create overlay file for this project and remove few led...
Hi Nordic Team,
The OpenThread API function otCryptoAesCcm() is not working after updating to NCS v2.6.0.
Setting CONFIG_OPENTHREAD_NRF_SECURITY_CHOICE =y seems to...
Hi!
I'm using some common bootloader code for different devices. One of my devices is a bit different, with an LED library that caused me to increase the BL size in the...
hello Nordic
i am using ncs 2.8.0 with nrf52832 and mrf52840
i am decoding a cbor file with the 'zcbor_map_decode_bulk'
the 'my_implementation_decode' is just a function...
Hi,
I'm polishing up the development of my product, and I need to use the LPCOMP driver to wakeup my NRF52840 from the deepest sleep mode. There is not much information...
