Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hi,
I want to use a single firmware to be flashed on two devices that can be used as a ble peripheral with DK Button 3 and as a central with DK Button 4 .
I chose ble_app_multirole_lesc...
Hi guys,
i am using nrf52840 controller.
and in that i have mbe at 0x0000000 location.
i have two bootloader stage. that boot1 and boot 2.
boot 1 i am using to validate...
I have gotten the FDS_ERR_NO_PAGES issue multiple times now. In our last pre-production run, it randomly happened to a few units (4 out of 60). For 3 of the units, the error...
Hello everybody, i succeeded to get the output from BME280 and MPU6060 sensors I need to merge them together
Kindly, I need help to Setup prj.conf file
Thanks & Regar...
Hi Team
The max value of IOH and IOL is the total current of all GPIO, or It is the value for each of GPIO pin？
I have read the post https://devzone.nordicsemi.com/f/nordic...
I used 9160 to develop a project for the customer. According to my design, an apn needs to be set before connecting to the NB-iot network. However, when I used at command...
I wrote a bootloader code. The flash space range of bootloader is 0x27000-0x3b000, and the flash space of app is 0x3b000-0x80000, but the app doesn't work. What's the problem...
Hi, I am trying to implement a Data Logger using nRF52832. I am using a Temperature Sensor to get the Temp readings(logs) and a Flash Memory to store those logs. The data...
I tested the Android nRF UART app. Now I'd like to test the same on Windows. If the source code is there, the better. If it is in C ++ even better.
Can someone give me a...
I am at the prototyping phase.
My nRF52 device discovers services on the phone (like Current Time Service, Battery Service, Apple Notification Service, etc…).
I want to...
Hello, I would like to collect GPS and sensor data from the Nordic thingy91 module, then send them to the influxDB cloud without going through nrf Cloud, because nrf Cloud...
hi,
I have a question about the communication between nRF24LE1 and nrf51802.They communicate using the Gazell protocol,Can you help me solve this problem？
1.The communication...
