Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hello everyone,
I've noticed that the Bluetooth and ADC work great together BUT I'm having issues when trying to turn on & off the Bluetooth.
I've tested the on & off...
Hi,
I'm working on hid keyboard example. How can I check whether multiple bytes are received & transmitted after I increase the assigned no. of bytes in input/output report...
Hi,
I have a ncs project which currently has only the main.c file.
I want to create a header file and the c file to be included in the main.
What's the recommended way...
Hi Nordic Team
I've applied all the changes recommended on https://devzone.nordicsemi.com/nordic/short-range-guides/b/getting-started/posts/nrf52840-dongle-programming-tutorial...
Hello everybody
I have some nrf52840-DKs and other boards with the same module and I want to create a LE Coded mesh with these boards, I am aware that the BLE Mesh standard...
Hi,
I am using the low power node example and light switch server example from nRF5 SDK for Mesh v5.0.0.
I have one board as LPN to make friend with one board as light...
Hi,
When I bond with a central to my device, the peer gets added to the whitelist. But I want my device (peripheral), to automatically start advertising in whitelist after...
Since mac os catalina, all command line tools must be code-signed. Your nRF-Command-Line-Tools_10_12_2_OSX distribution is not code signed, therefore cannot be installed on...
Hi all:
I found this issue happen on NRF52 with SDK v11.0. Because I measured the current increased ~1mA after enable GPIOTE->IN, is there any solution can solve it?? Thanks...
Hello,
I have two nrf52840 DKs.
I can get the central to connect based off the device name or a specific UUID but what I want is the central device to scan for the peripheral...
Hi,
I have following questions with reference to two different bootloader scenarios with my custom nRF52833 board:
1) UART based: do I absolutely need RTS, CTS for this...
Hello guys ,
I am using nrf52833 board with nRF5 17.2 SDK on KEIL IDE has softdevice as S140 wants to implement six pin authentication password on nrfconnect app in mobile...
Hello!
Sorry in advance for what is probably a very simple mistake. I am currently trying to develop a simple PCB for the nRF5340 QKAA aQFN94 package using EasyEDA (bare...
