Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I use ble_app_uart（sdk 14.2） + light_switch（mesh1.0.1）
Questions are as follows:
1client + 1server is ok, but in the second server there will be network failure!
log...
Hi,
I'm trying to get the tftp example working from the sdk iot examples. When I try it out following these instructions ( http://infocenter.nordicsemi.com/topic/com.nordic...
Hello,
i'm using the BLE Nano v2 with the nrf52832 on it and a DAPLink USB-Dongle. IDE is Eclipse with gcc and SDK v14.2. My current aim is to do an OTA DFU so I tried the...
I have a custom board, that basically consists of a nrf52832 module (ebyte), a button and a LED. The LED is connected as in pca10040: VDD->220R->LED-> ground to p17.
I assume...
Hi, I'm attempting to run the Proximity example ("ble_app_proximity_pca10028_s130") on my nRF51822 dev kit using the S130 SoftDevice. I am able to connect to the dev kit ...
Hello DevZone, I have few questions relative to the design of the PCB antenna for a nRF52840 chip. I'm going to use the Eagle library find on the github. But... 1) Why the...
It'd be great if the Nordic nRF5 SDK team had a bit more time to test the code under C++, to shake out a few smaller issues.
Here are some changes that needed to be made...
Hello world.
I wanna ask about how to convert arduino code possible for mbed compiler for arduino. first of all, I have tried to use this guy program knn arduino code ....
I'm attempting to build a project to use easyDMA with PWM, but as there are no applicable examples in SDK 15, I am working on it myself. I originally asked for help here:...
Like the subject says, when I attempt to search at http://infocenter.nordicsemi.com, the search results show the following forever. The browser reload/X button keeps flashing...
Hi,
I created a mesh network with a mesh model which allows me to send a string message over it.
I use one board with a provisioning role and 3 others as provisionee....
Hi team,
Let me confirm what's C0 in the nRF51 32MHz XO spec. It specifies as following but C0 definition cannot be found in the PS. I assume C0 is the load cap where C1...
