I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
I found many relative topics about improving throughput for ble link on this website. And this one How do I calculate throughput for a BLE link? told me how can I calculate...
Hi!
Whether there are any special requirements for SPI chip NRF24LE1 labeled NRF B 24LE1D ?
My programmer (mPro) do not work with this chip SPI.
rergards,
Andrii...
Hi all,
I am new to the EE/hardware world. Coming from the CS side, I am trying to grasp little bit of knowledge every day.
I looked at the reference designs and am...
Hello,
i have just a short, easy question, but i couldn't find the answer in the datasheets.
Normally the ports on the 6310 board can deliver ~3.3V. Is it possible to...
Hi,
I cannot find "Master Control Panel" for MacOS, can I test with iOS or MacOS itself? None of them seems to able to discover my PCA10001 running S110+nAN36 LED.
Thank...
Dears :
we will use WLCSP package. And, we want to know more information about it as below:
1.Marking side is strong enough right?
2. We only need to take care of side...
Hi,
I am new to ble stuff. I want to write a hex value (0403FEA27469) to a characteristic on the heartrate device.
Following is what I have done so far.
Can anyone...
I am trying to send some data between devices using the micro esb library while still running the BLE peripheral stack. My code is based on the sample nr51-micro-esb. Are...
I was using TIMER1 PPI and GPIOTE to setup a PWM signal on a GPIO line. This PWM will start and stop after 1 seconds. I used led.c to based my code. I was starting the Timer1...
Hi,
I'm having a hard time figuring out how to load and store application context from the device manager without being connected to a peripheral.
According to the device_manager...
hi all:
how to use sd_ble_gattc_relationships_discover to discover att handle?
as my question Use Nordic BTLE Soc with other Vendor BTLE Compatibility
i found this...