Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
It used to work, but now it says "Connected" but the rest of the GUI never changes and the mouse just shows a busy spinner. Here's the log file:
0;13:45:18.9900 [MainThread...
Hey guys. I have some question.
Until now, I wanna use TFT LCD (LCD Demo 320×240 RGB(565) on nRF52840) and I'm trying to do a similar experiment now with you. I want to...
Hello,
We are using a NRF52832 in our product with Buttonless DFU. In a new version of the product we are exchanging the external LF Crystal for a LF Clock source.
As...
Hello,
We ae using NRF52840 MCU in STOP Mode 2 with RTC on 3.2V battery. We use GPIO Interrupt to wake up MCU by a Push Button. So, for that Active Low Edge Trigger Interrupt...
Hi,
I am just starting to use nrf connect sdk for 5340; and wading through the confusion or build systems, west, SES, Visual studio; no clear path.
As we have used SES...
Hi,
I would have thought this was easy but I cannot seem to find a way to prevent LOG_INF etc from adding a line break to the log string.
I am using NRFConnect with Zephyr...
Hi,
I have TWIM communicating successfully with a slave device on the PCB.
We now need to support some PCBs populated with the slave device, and other PCBs where the slave...
I have a product running on an nrf5340 and part of it is running a nordic sample project. In the sample project there is a call to `k_msgq_get()`. The program spends a lot...
Hi
I'm evaluating the nrf5340dk devboard and are building a simple application on top of zephyr. I'm using Cmake and ninja on Ubuntu. The code builds and I'm able to flash...
Hi there,
We are currently doing some testing around the low power modes of the nrf5340. Detailed info on the Low Power mode and Constant Latency mode is a bit hard to find...
I'm trying to get my nrf9160dk board up and running with the nrfcloud service. However, when I input the SIM ICCID and PUK, the nrfcloud site starts it's "working" process...
Good day
After flashing a sample to my thingy 91 I seem to have lost the Jlink connection. All im picking up is the UART via nRF connect Programmer. Is there a Bin file...
Hello Sir/Mam;
I am new in nordic environment so i need your valuable guidance . i want to read a sensor data using Uart . I have successfully do same thing on Arduino board...
