Hi Team,
Is it possible to implement the iOS application to track the iBeacon Component after closing the application(Background processing).
Please provide any example...
Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
Hello,
I am developing using NRF52832 and nRF5_SDK_15.2.0.
I am using FDS to manage some data.
Size of each data will be 20bytes. I like to store maximum 1000 data...
Hi,
We modified the lte_ble_gateway example and connected to our aws iot server. And have faced few issues so far and would like to get some hint from you.
We are using...
This question was asked, not answered, and locked. So I will ask it again
I changed the security settings on a CCCD for a heart rate measurement characteristic and got...
Hello,
I have troubles with the timer interrupt. The code work fine until the timer hit the compare value and then stop.
This is my function for the timer init:
Here...
Hi,
I have a problem with the BLE mesh light example using the static provisioner. I have modified the example to have multiple Generic OnOff servers. Client and Servers...
Hi, I'm a beginner of Firmware Engineering and facing an issue on programming of sensor module.
I am using a sensor as IIS2DLPC made by STM, and board is nrf52840 dk board...
I am re-starting a project to send MQTT topics to AWS. At this point, is MQTT_Simple still the best way to start and then modify the endpoint as suggested in case 224855 or...
When i call the sd_ble_gap_adv_start function then after a few seconds the mesh communication fails because the scanner_radio_irq_handler is not called/triggered anymore....
Dear,
I started a new laptop Windows 10 Pro
installed nRF Connect, and followed the Started Assistant
installed the toolchain
downloaded the SES (v4.20a)
----...
I have NRF5252840-DK (evaluation board, SDK 15.3.0, S140) acting as central. It correctly scans advertising data from my peripheral - custom board with NRF52811 (same SDK...
Hello,
I am working on nRF9160 DK development platform.
For that i Compile & run GPS example, But while debuging that example i find that mcu stucks in CPU Idle function...
Hi,
I am currently trying to program an external module using the nordic nrf52840 development kit debug output pins. I have the following connections that I have taken from...
