Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hello,
I am working on the NRF5340 DK board with nRF Connect SDK ncs v1.5.1. I want to transmit data at a fast rate (~ 200bytes at every 10ms ) from central to a peripheral...
I am developing a product using the nRF51822 BLE, I was able to interface all my peripherals and setup the softdevice stack accordingly.
Now I am looking to add a pairing...
Hi Dev team,
I have an application working on the Thingy91 that sends the data of the sensors through MQTT to our server. I was interested in knowing the data usage of the...
Hi All!
I'd like to ask if anybody succeeded running zephyr without optimizations?
For ex. i have a following code:
Now i have following problems: 1) If i set...
Hi,
We got carrier frequency tolerance failure in a certification test.
The max deviation should be under 20ppm, but the result is above 30.
We used DTM example...
I'm working in a project where I have to use produce a PWM signal which actively drives the pin low for 0, and disconnects the pin for 1. The PWM is generated by an in house...
Dear Members,
For checking my LF 32KHz crystal is working,
XL2 is the output of the crystal ? or vise versa ?
So XL2 to the scope and the other probe to the ground...
Greetings,
I'm trying to develop a project on the nRF5340 DK where I collect measurement data from an I2C sensor (LPS27HHW) before sending the data via bluetooth. My firts...
Hello i'm trying to run a sample from my projects but each time i'm getting the CMake error i tried changing project and running from another directory but the problem still...
Hello,
we try to add DTLS to the CoAP client example . We have problems with the DTLS connection. The handshake with PSK works. The first CON or NON query works also without...
Hi! I developed a locator and beacon pcb boards for AoA direction finding using the NRF52811 chip. The locator has 4 patch antennas and the SKY13575-639LF external antenna...
Dear Members,
I want to use MAX17048 and getting thiis message :
<error> app: ERROR 33281 [NRF_ERROR_DRV_TWI_ERR_ANACK] at ..\..\..\MAX17048.c:71
void MAX17048_init_i2c...
I have found an issue with ESB/Nordic radio where it will receive a packet on the wrong pipe. I think the issue occurs when the prefix array set to the PREFIX registers contains...
While testing our custom Hardware with the nRF52840 in a climate chamber in the -40°C to +85°C range i noticed that the value read from the internal temperature sensor was...
