Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
I am using the simple code below to generate a signal from a memory buffer. I cannot generate a signal cyclically. If ONE sequence is used, then the buffer is played once...
Hello,
The flash memory of my existing project originally occupied about 200kb, but suddenly the capacity increased to about 255kb.
So I checked and found that the amount...
Hi
I'm doing a project using the TimeSync library (latest version) on 2 nRF52832 development boards.
I've ported the library to my project, the time synchronization...
hi, all. I'm using nrf52833, pca10100, s140.
The flash memory capacity has increased, so I checked the memory, and it seems that the log values have been saved.
It should...
My mac (and the nRF connect Programmer) no longer recognizes my Thingy91 when I connect it via a micro-USB. I am unable to use the nRF connect Programmer to flash my device...
We have had our nRF52840 based Zigbee Coordinator in production since September of 2020 with great customer feedback. Unfortunately, we have recently had several instances...
Hi,
I am new to Nordic cellular modems, but plenty experienced with other modems. I would like to evaluate the nRF9160 as a potential candidate for future use in our products...
Hello,
I am having a problem nearly identical to this link Using soft device on custom board with nRF52840 - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com...
Hello,
I am running a single ( main() starts sysworkq thread) thread application in Segger Embedded Studio v5.34a, built for the nRF52833 SoC.
Although I am using a proprietary...
Hi
We are seeing a strange issue when trying to use the Android BLE Library to Android BLE Library to reconnect to two devices. The phone succeeds in connecting to one device...
Hello,
I am going to run DFU over the mesh.
I am using an nrf52840DK and two nrf52840 dongles. I want to send a DFU file through the serial port to the DK and then through...
Hello,
during production test we wrote in the UICR a signature saying that the test has been performed succesfully.
It happens that the signature is not written correclty...
