Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi, I want to create one system. When master writes data of Nordic, I receive callback with BLE_GATTS_EVT_WRITE case. Here I want to write return to master with success/ failure...
I have just started developing my first bluetooth application and came across an hardfault during softdevice handles the Radio Interrupt. Since I'm fairly new to bluetooth...
Hi Support Team,
In new PS v1.1, two more capacitors are drawn in reference circuitry, Why are they needed? And how to tune these four capacitors (CT1, CT2, CT3 and CT4...
Hi everyone, I have two PCA10056 and I would like to use one as sniffer but the nRF-sniffer-V2 doesn't support this board. The subject has already been treat in this post...
Hello
System:
Windows 10
nRF Connect v2.6.0 and Bluetooth Low Energy v2.2.0
Python 2.7.13
After some research I didn't find any examples of bonding with pc-ble...
Hi,
I am using the nRF52840 with no soft device, and I am experiencing an issue with SPIM3 when turning on/off the ArrayList and Shortcut (EVENTS_END and TASKS_START) where...
Hello
I'm looking for some information about flash erase/write currents for the nRF52840.
Somewhere here in the forum there where values mentioned about 4mA for flash...
I have installed "nRF connect v2.6.0" for desktop under Windows 10. Same behaviour with "nRF connect v2.6.2"
I want to use a nRF52840-DONGLE (PCA10059) as central.
I have...
Hey,
I'm building an application where I control both peripheral and central sides. Both sides are custom hardware with nRF52840s with softdevice s140 v6.0.0 using SDK 15...
Hello, i have a trouble that stock me several days, i'm using sdk15.2 on nrf52840, and i want to do scanning using whitelist, please help me, here is the situation.
i have...
I have been having trouble creating a new project with nRF91 and Zephyr so I've decided to begin by modifying the "asset_tracker" example project.
I need to add the arm...
Hi,
Referring to the figure at the end of this page:
infocenter.nordicsemi.com/index.jsp
I have a question regarding the MBR parameters and the Bootloader Settings...
Im not entirely new to the embedded world, been programming since I was a kid and been working on embedded projects for 3 years now.. In fact the few first steps I can take...
Hello, I just want to set one random static bd addr using mesh SDK v3.1, and it seemed I have set correctly, but the SOC(nrf52840DK) still use the default bd addr which is...
