I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
HI,ALL！
I tried to add a RTC wakeup funtion to my ble device, so i add the code of the Nordic board example named "rtc_example" to my program.
But it turned out that my...
Hi,
I'm working on a Keyboard&Touchpad project, very similar configuration with Smart Remote 2, so I'm considering to use nRF24LU1+ as receiver's MCU. The receiver will be...
Dear Nordic,
We are performing current measurements on a nRF-9151 DK using the Power Profiler Kit II. The attached picture shows the 9151 and PPK-II connected. Notice that...
In the documentation, its suggested that the antenna should have a matching network between the WLCSP NRF52832 and the 50 ohm transmission line that looks like this:
...
Hi nordic：
What is the required voltage ripple range for the nrf52820 when powered at 3.3V, and what is the normal output voltage range for DEC6?
Best Regards！！
jer...
Hello, After receiving thingy91x scanned the QR code on the prototype board i get the following message
Connection failed.
The fingerprint you have provided is not recognized...
Hi Nordic Team,
Good week
We like to confirm a few technical details about the NFC-A tag interface on the nRF52840 :
What is the source of the 13.56 MHz carrier...
Hello,
I am trying to update a project from SDK v2.6.1 to v3.1.0 , but with the updated SDK my device is not able to connect to the network anymore:
I also made a temporary...
I am porting a ncs project from nrf52832 into nrf54l15
If want to reuse existing Log functions of system of zephyr, like supported by NVS, is there any way to do it?
Nordic...
In the first steps of this lesson, we create a new directory for our custom board called my_boards. In VScode, we then Create A New Board with the board name etc. and then...
Hello,
I am trying to communicate with an SD Card with a NRF54L15DK but it doesn't work. Here is my different files :
& spi21 {
compatible = "nordic,nrf-spim" ;
...
I am using nrf52833 DK, v3.0.2 SDK
The example can be found at https://docs.nordicsemi.com/bundle/ncs-latest/page/nrf/samples/bluetooth/peripheral_bms/README.html.
Connect...
Greetings,
In the process of adding the RTC driver to the project I am encountering a build error when I try to setup a device pointer. The offending line is:
const struct...
i'm already able to TX and RX arbitrary packets between my own bare-metal test programs running on a pair of DKs... since both programs used identical configurations (mode...
