Hi ,
I would like to know if a matching network is needed if I am only using a single external flex antenna for both LTE and GPS using a RF switch between them and a uFL...
I am a student interested in Nordic.
My coding skills are very poor.
So I want to get help.
I want to use the vl53l1x sensor in nrf52. (My ultimate goal is to measure...
I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
MCU: nRF52840
IDE: Keil uVision 5.17
SDK: 15.2.0
Board: Custom
OS: FreeRTOS
Using MicroLIB
Hello,
I am currently working on a FreeRTOS project that leverages...
Hi,
Based on the below extract:
"Because older devices that don’t support Bluetooth 5 will not be able to discover extended advertisements, an advertising set with legacy...
Hi, I am currently using the PPK2 for current measurements.
According to the datasheet, the PPK2 supports a maximum source voltage of 5 volts. However, my device requires...
Hello
we are certifiying our product by ISO 13849-1 which includes the Nordic nRF52832, among more information I would like to start with the following questions
1. where...
Dear nordic support
We're in the concept phase of a product that implements cellular cloud connectivity.
We already implemented a "blueprint" ESW which provides supporting...
Hi,
I am planning to create an ultrasonic library (based on ch201) because I can't find any library for it. So I am porting code from ch201 development kit to nrf52 custom...
Hi there,
I have a Thingy:91 board and I would like to enable the accelerometer data to be sent to nRF cloud when using the Asset tracker v2 application. I saw that it is...
Good afternoon,
I'm trying to understand how the RTC works on the nRF52.
The RTC can run when HFCLK is OFF and PCLK16M is not available
Section 25.5 describes the TICK...
It appears that KConfig is uable to find any compilers for native_posix with VS Code on windows 10 after installing all recommended packages and prerequisites during SDK install...
Hello,
I am using LwM2M library in my project and I want to check what version I am using of LwM2M carrier library. Please correct me if I am wrong, is according to below...
I am creating software for a proof-of-concept device using the nRF52840 Dev Kit and nRF Connect for VS Code.
I started a few weeks ago with the Nordic UART Service code...
With Zephyr, I am using BLE Stack sample (rpc-host) on net core and peripheral_uart on app core. I changed the uart pins on from the standard dvk configuration on devicetree...
Hi
I was wondering why there there seems to be no information about profiling of the LC3 codec by T2.
Only information I found is from Karl's answer here :
The rule...
Hi~ I have a new NRF52832 REV3 xxAA board, and I need to read its SRAM value. However, when I use the JLink command to read it, I get 0. I have tried recover and eraseall...
