Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
I am having trouble figuring out how to put system in PM_STATE_SOFT_OFF from inside workqueue. If I put system to sleep inside workqueue it does't go to sleep, looks like...
I'm having some issues regarding the data update interval when running the asset_tracker_v2 application, particularly with adjusting how frequently it publishes data to the...
Hello
I am trying to upgrade a nRF52840 dongle via USB but it fails every time. I tried with my Ubuntu laptop and with a Raspberry pi 4 with same failure.
nrfutil dfu...
BLE_HCI_REMOTE_USER_TERMINATED_CONNECTION Hi,
I've implemented a Central role application on the nRF52832 that scans for a particular Peripheral (with a specific UUID into...
sI am trying to turn on or off switch. When I measue voltage on feet of the switch it is always 3.3V. There is no change. I am setting pin on or off and I get state of pin...
MPU6050 cannot calculating the value of 3 axis and the value return is 0. What is problem? How can I fix it ? Thanks for helping me. AD0 open.Adress is 0x68
Here is my...
Hi，everyone：
I tried HSS mode, but it can't meet my needs.
When I use RTT mode, the configuration is as follows
test code:
RTT viewer:
but, J-scope has been...
Hello All,
I have ported the UART example ( <InstallFolder>\examples\peripheral\uart ) on top of blinky in nicla sense hardware. The TX is working only when rx pin is set...
Hi,
I'm trying to build a proof of concept for a BLE gateway that captures data from BLE sensors and sends it to the cloud via LTE-M connection. I'm hoping that the gateway...
Hi, we are developing a project based on the LWM2M client, everything is working fine but now we need three non volatile variables. We did some testing with the nvs example...
Hello,
I have recently been able to connect to multiple sensors using the nrf connect 2.0.0 SDK and nrf 52840 dongle as a central device. I was wondering how I could configure...
Hi,
I would like to create a multiprotocol BLE/Zigbee coordinator project on NRF5340 with VScode.
I can't find an exemple nor guide on this except from this one:
https...
What does this error mean?
here is my error massage.
<info> app_timer: RTC: initialized. <info> app: Debug logging for UART over RTT started. <info> app: Connected <error...
