We are finishing up a project with the nRF52832 based on the Nordic Thingy. Most of what we want it to do are normal functions of the Nordic Thingy. It connects to a mobile...
I feel like a crazy person looking to store large amounts of data onto an external chip that is not a micro-SD (why not micro-SD? It's power-hungry and finicky ). NAND through...
Hi
I try to run BLE HRS collector example.
when I run the project, in RTT terminal I have these error
00> sd_ble_enable: app_ram_base should be adjusted to 0x20001CD8...
Google open-sources the firmware needed to build hardware security keys
Google open-sourced today OpenSK, a Rust-based project to aid hardware vendors build hardware security...
I would like to store a simple integer value in the flash write and read after some event. I'm using the mesh example Dimming examples (experimental) in the nRF5 SDK for Mesh...
Hello,
Has there been any success with getting the python bindings for the pc-ble-driver running on openwrt? I've succeeded with the driver itself but not the bindings....
I want to write numbers in my flash memory so I used this function "nrf_nvmc_write_words" but in it couldn't save float numbers in my flash memory
it is like that in nrf_nvmc...
Hello All,
I am using nrf52840 in my project. So basically the architecture is the sensor devices(ble peripheral) get connected to the central module(ble central). Now I...
hi support team,
customer is finding that 832 erase page takes more time than normal conditions, that is when the temperature is -20, erase speed is much slow.
as our...
Hi all,
I am confused about nrf52832 Tx/Rx max current. I am using PPKII measure the power current of NRF52 DK PCA10040 , As the following screen shot, :
In DC/DC mode...
Hi,
I'm working on a custom board based on PCA10100, nrf52833 but it seems to be stuck at the function "lfclk_spinwait".
my custom board does not have an external LFCLK...
Hello,
For my application I have a need to buffer data for, say, 8 GPIO pin outputs and continuously generate those buffered outputs in parallel on the GPIO pins. I have...
Hi,
According to the BLE core specification, a host can communicate with multiple controllers via HCI. I want to confirm whether zephyr's BLE stack supports the feature...
Hello,
I am working on a project using the nRF5340. I will eventually be supporting OTA DFU for both cores so I need to be able to statically define the partitions for both...
Hello, I am porting to nRF5340 from nRF52833. Previously, we were using sdk17.0.2 for nRF52833 and we were able to successfully implement encryption algorithm AES-CTR-128...
Hi,
I have a NRF52840-DK (400236). I was using it for the development. It was working perfectly.
Suddenly the issue arises the power section is heating up.
I am powering...
Hi,
I am running the standard Grove LCD code, as below but am getting an error, " Grove LCD: Device not ready.'
the code is
my overlay file is
and my proj...
Hello,
we have a set of router devices already on the market: each of them was developed using 4.0 stack.
now we're aligning the stack to the 4.2 version observing a very...
Hi!
I've followed the app timer example to implement app timers in my project. My project is low power consumption oriented. When I use a repeated timer, power consumption...
Hello,
We are integrating the nordic sdk for DFU on our own application on Android and iOS.
We need to know al the possible error codes that the sdk can sent but we...
