Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
I have a fairly simple ESB application that was working with nRF Connect SDK v2.1.3 but is not working with v2.2.0. I was able to bisect the SDK and isolate the issue to a...
Hello,
I was coming across the I2S timing parameters of the nRF5340 gvien in the data sheet, see below screenshot. The SDOUT setup time is specified only as a minimum value...
Hello,
I am currently trying to get our nRF52 development workflow working in a Docker container. I have been able to compile the firmware in the container and debug it...
Hello,
We are currently evaluating the nrf5340 using the "nrf5340 Audio" development board. Part of the evaluation is to verify if the device can handle 3 TX mono streams...
Hi,
I am trying to implement LESC bonding into my nRF51 application. After a lot of debugging, I assume that pm_lesc_public_key_set() needs to be called before any secure...
Hello everyone,
I am working on a bluetooth camera project using the nRF5340 DK and SDK v.2.2.0. Since the Image data is quite large, I want to store it in a Text file for...
Hello,
Right now I am trying to disable perticular RAM blocks. But I can not find the adresses of the RAM blocks (where block1 starts and ends, where block2 starts and...
Hello, we are using the Bluetooth module BL651 which should be using the nrf52810 chip soldered on our custom board. I followed the documentation installing the appropriate...
Hello, I want to manually perform RSSI measurements, which I am doing as described in the specification of the nRF52840:
Call RXEN task
Call START radio task after READY...
I am trying to easily switch between having CONFIG_LOG enabled and disabled using a makefile, and a file called overlay-log.conf which contains only the line CONFIG_LOG=y...
I would like to configure and use a mesh network based on nRF52833 devices. One device as the proxy gateway connection to a mobile phone or tablet, and up to 40 mesh nodes...
Hello Everyone
I realized that break points cause the main thread to restart if I use ble advertising (verified first in my firmware and then in the official examples: I...
I've been writing this FOTA solution that would work together with an existing server we use together with Onomondo connectors.
And I've been running into this issue when...