Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
I'm trying to add addtional pins as PWM signals in my application. I've followed the process shown here , but I'm getting a bunch of build errors.
This is my overlay file...
Hi Good Day,
Please I am fairly new to the nRF framework and I am facing some problems with a project I am working on. I am trying to interface a load sensor with an nRF9160...
Hello everyone,
I am trying to send some data over to the MQTT broker using the Thingy91 and the example of 'Cellular IoT fundamentals - Lesson 4'. The example itself works...
1: In TX mode, according to the example input instruction, set +4dbm, the test to the peak power is -19dbm, according to the example input instruction, set +19dbm, the test...
Hi,
I've been successfully working with and building applications using the "freestanding" option in VSCode.
However, now comes a time where I want to switch over to...
I just receive a nRF52-DK and purchased a Waveshare 1.3inch lcd module. I am really new to this but wanted to create a simple "hello world" with it using Arduino. Is there...
Hi I implemented nrf_cli on my device to communicate with a computer. As a consequence the energy consumption rose (even when I am not using the CLI).
I don't mind if the...
I am using nRF52840 dongle for prototyping an IoT product. I have cut SB2 and soldered SB1 so that I can flash the dongle thru SWDIO and SWCLK instead of thru USB. Can I use...
Originally, I wanted to achieve a simultaneous multi-image OTA DFU of both the app core and net core on the nRF5340 (via BLE). According to most resources online (namely,...
Hi,
In my project I make use of the PPI to connect the comparator with the counter (timer). But as soon as I enable the zigbee stack, especially when invoking the zboss_main_loop_iteration...
Hello everybody,
i need the technical drawings for the nrf52840DK.
All i can find are some dimensions from the board itself ,see figure, but i want to make my own board...
Hello,
I am working on a thread based project for a class and I am unable to ping anything from an end device inside my thread network.
RaspberryPi 3b - connected to...
Hello, I've just started leaning zephyr rtos using Nordic 52840-DK. I was thinking to write a code in which i can set a pin High/low using uart interrupt method. Is there...
We encountered two bugs in our own firmware that put the device into a really bad state and so I wanted to ask what the practices are to avoid this.
One bug we got stuck...
Hello,
during advertising, the measurements done with PPK2 show unexpected peaks.
Advertising parameters:
- interval: 1,8 sec
- TX power: -12 dBm
This is the...