Hi everyone,
Currently, I am working on my bachelor thesis for creating simple network by using MQTT, BLE-6LoWPAN and nRF52832. I have three nodes of 52832 and one raspberry...
Hello everyone!
I want to form an Openthread network with three Nordic nRF52840 cardboards. I would like to monitor the traffic using a sniffer, but i can't receive any...
We are using the development board PCA10040 for implementing a prototype with several GPIO interruptions.
We are trying to use the NFC pins (pin 9 and 10) as pins of GPIO...
Development Software:
nRF5 SDK for Mesh v3.1.0
SEGGER Embedded Studio for ARM v3.50
SoftDevice S140 v6.1.0
Computer Platform:
Windows 10 Professional
Hardware...
Dear,
software/hardware:
nrf52832 mesh sdk v3.1.0
Q1: when friend feature node code can get? now just is bin file.
Q2: mesh has just four feature devices, friend feature...
It seems the LTE-M / NB IoT isn't available Europe-wide yet, and roaming applies country-wise.
Can anybody share his/her experience of using the BLG840F?
thank you.
Hi, i'm trying to modify the thread coap_server sample by adding bluetooth configurationg following this webinar https://www.youtube.com/watch?v=hY_tDext6zA&t=2199s
I'm...
Hello,
I'm working with the nRF Connect SDK version 1.8, using Zephyr and a CC1101 radio module. The radio communicates via SPI, but at the beginning of the process, I need...
Hi
which function do I need to call in a peripheral to stop advertising?
Where Do I find the documentation for it?
which function do I need to disconnect ?
Where Do...
My company has been assigned a 16bit Service UUID from Bluetooth SIG, which we wish to use in advertising with the Service Data AD type.
However as soon as I swap our binary...
Hello, I was wondering if somebody has an explanation (or has seen the same problem) for the following event:
We have had 5 units with NRF9160-B0 in the field for testing...
Hello, On my nRF9160 custom device, I have enabled XPOFWARN to automatically switch off the modem in case the voltage gets too low. It's working fine. This case happens when...
Hello Engineer Greetings Of the Day We performed DFU over BLE with secondary slot in External flash that operates using SPI . I needed some clarification on the outcomes ...
We have a custom board with nrf5340 and we use SDK v2.5.3 for software development. Our BLE signal strength seems too weak with the default TX Power setting. So we would like...
Dear Team,
May I know how to install Nordic Edition of SEGGER Embedded Studio?
I did not see any executable file after downloading.
I ma onlz seeing the below files...
When building the Matter weather station sample, without any changes, I see many warnings regarding incorrect project configuration, such as conflicting options or missing...
I attached an external nRF52840 to the debug out port of the nRF 7002 DK (as seen here ), but cannot get a connection to the external uC.
I know the cable and uC work...
Hello Nordic community,
I’m working on a project that primarily uses GPIO for controlling locks, Bluetooth communication, and is powered by a battery. I’ve attached the...
Hello，
I am using a customized NRF52832 circuit board. During the Bluetooth connection test with a mobile phone, the connection suddenly disconnected, and then quickly reconnected...
