Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Hello,
I have an application that I receive data over the UART. The data being received can be of different lengths e.g. 12 bytes up to a maximum of 256 bytes. I want...
Hello,
I only want to know if it is possible to enable and configure the Server Name Indication (SNI) for DTLS on BSD sockets and CONFIG_NET_SOCKETS_OFFLOAD=y (not using...
Guys,
I am able to successfully build zephyr/samples/hci_usb for nRF52840 USB Dongle, but the same sample code fails while trying to build for nRF9160-DK
Works as expected...
Hi! I'm working on a mobile application that interacts with an NRF52 device. We'd like to be able to programmatically reset a device stuck in DFU mode so that it tries to...
Hi,
I have never used Nordic devices before so apologies if these questions are answered well somewhere, I just can't find the best article anywhere.
The project I am...
Hi, I have built a BLE-enabled sensor that is capable of measuring the air flow and volume passing through a pipe. A new sample is generated every 10 ms.
In the language...
Hi,
I am currently developing a project using ultrasonic sensor for measuring level. So I was migrating library from development kit to nrf sdk code. I am using Keil uVision...
I am trying to interface winbond flash with the 33 board using ncs and VS code , I am able to get the code to compile and not receiving any errors , it is working and no matter...
I'm trying to use `bt_hci_register_vnd_evt_cb' to register a call back to process vendor specific hci events.
below is my prj.conf
my callback function for testing...
Hello, Everyone. Now I am trying to develop a BLE mesh firmware using my customized nRF52832 board. I followed this tutorial https://youtu.be/ufjv2NaLfN8?t=1745 But I can...
Dear Community,
Why is the nRF Connec SDK is mixing up path separators '\'and '/' when building under MS Windows 10
with nRF Connect Desktop 3.12.0 / toolchain manager...
I've been following this blog post to increase BLE throughput for my application: Building a Bluetooth application on nRF Connect SDK - Part 3 Optimizing the connection -...
I'm using nRF5340 DK for BLE, AoD (Connection). I am also using the TX example from nordic. I can add extra antennas to the ant_patterns[] (up to 17), with no errors. I also...
Target nRF52832(nrf52dk_nrf52832) SDK NCS v2.0.0 I'm testing NCS 2.0 with Android 12. Making pairing with Android, I call two API when connected.
bt_set_bondable(true);...
