I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi,
I am trying to implement external flash storage onto my custom board, featuring an nrf9160-SICA-B1 and a Winbound w25q128jv 128Mbit flash chip on SPI3 (I cannot get...
Hello,
we have a problem with modules from raytec MDBT42Q.
We have modules which work with our software as expected, and other ( newer ) that will stuck in Software. ...
I use the following :
-> nRF52840 Dongle / µC on the other side
->Blutooth Low Energy v3.0.1 (desctop version)
I try to read a characterictic after connecting and get...
During an execution of a winbond w25q64jv command (any command) during a BLE_GATTS_EVT_WRITE event the SPI bus goes inactive after the command is sent:
There is apparently...
Hello,
I tried to change the defined UUIDs for the BLE service and characteristics in the LED Button Service example (lbs.h).
E.g.
But the result is somehow...
Hello, I found that my device is more prone to disconnection due to 0x8. And I saw the log and found that most of the disconnected cases were immediately disconnected as soon...
I am using the NRF distance measurements examples between two nRF5340 boards to calculate the distance between them. I want to know how the distance is calculated in phase...
I am attempting to download v10.18.0 of the nRF command line tools for Linux x86 64. However, the .deb file provided is for arm64. Could you please fix this in the nRF command...
While trying to download the latest nrf-commanline-tools for LInux x86_64 I have noticed that the link for the DEB package is wrong: it leads to the arm arch., not the amd64...
Hi.
We've built an app for the nrf5340-based module using the nrf connect 1.6.1 SDK and its out-of-the-box Zephyr/MCU boot loader etc., code base. We build using west, which...
Hallo Team,
We are planning to use nrf5340 for one of our project which requires low energy audio and sensor data transfer. Can you please evaluate if our use case is...
Hi, I am currently developing on nrf9160 DK, and would like to set pins 0.14 and 0.15 as analog inputs to read data from sensors, similar to arduino uno, but not sure how...
Hi,
I developed a firmware without softdevice for a custom board with nRF52840
I recently decided to add a bootloader to my application and I based my bootloader code...
