I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
Hi,
I was using NCS 1.5.0 and Modem firmware 1.2.3.
I have latest DK of nRF9160.
It was running properly without issue specially LTE connection.
But after I migrated...
Hello,
i ran nRF Coap Client and it worked pretty well.
I am working with nRF9160 DK.
Now, I want to add DTLS to this example to secure the data.
Can someone please...
Hi.
I wasn't sure under what topic to post this but it's just a generic question I suppose. I'm still learning so please give it to me in plain English.
It took me a while...
HI Nordic,
As far as I know, in nRF5SDK, the maximum link number of BLE is 20.
I search for the devzone, someone said the number for NCS is 64.
So, I want to know: ...
At multiple places in the SPM subsystem code incorrect assumptions regarding the SRAM memory layout are hard-coded:
At line ~35:
This code is enabled when USE_PARTITION_MANAGER...
Hi.
We are working in a project that needs to exchange data via serial port. In this sample a virtual serial port is created in the nRF USB connector. Is it possible to...
I have custom board with nrf52833 SoC. its works fine with all example of NRF SDK1.7.1. except with ZigBee examples it did not works. I run Zigbee:Network coordinator with...
Hi,
I would like to know if it's possible to use the nRF52840 chip in nRF9160dk to join/create openthread network. When I tried flashing the thread CLI sample to the nRF52840...
Hello everyone,
I started with my program on the nrf52832. As a base I use the example multirole_LESC, because my focus is that 2 or more nrf52832 communicate with each...
Hi,
I want to storage some data in flash on nRF52810. When I open the "flash_fstorage" example and built it, there occur an error.
RTE\Device\nRF52832_xxAA\system_nrf52...
Hello,
I am looking to send packets of real time accelerometer data over uart to my PC via uart. The packets are similar to the code shown below where the data array is...
