I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
I am trying to get std::vector to work on nRF52840 running Zephyr in Visual Studio Code running v2.7.0 toolchain , but have been unable to do so. I found some similar tickets...
Hi nordic
I've try to enable 115200 baud UART on p0.9 and p.10 but I can't make it.
I just saw a thread about 52840 can't use 115200 uart at p0.9, p.10:
https://devzone...
Hello,
Is it possible to use the filtering options provided by the nRF52840 BLE sniffing firmware for Wireshark, in Tshark? Specifically the device address filtering....
Hello, I have two questions. 1. First, are these pins reserved in the SOC level or DK level? this if from the nrf52840dk device tree. meaning, if I have a custom board, should...
Hello,
I'm using an nRF52840 on a custom board operating in high voltage mode, powered either by a LiPo battery or USB. The design follows configuration 4 from the nRF52840...
bt_mesh_dfu_metadata_encode always adds comp_hash and elems fields to the buffer
However the bt_mesh_dfu_metadata_decode function checks if the fw_type is
BT_MESH_DFU_FW_CORE_TYPE_APP...
Hi Nordic DevZone Community,
I am currently working on a BLE peripheral application using the Zephyr stack and have encountered an issue where my device stops advertising...
Hi,
I am using SDK v2.6.1 with the nrf7002dk_nrf5340_cpuapp board.
My HTTPS code works fine, but when I try to merge the configuration files for BLE, ADC, WebSocket, and...
I am performing OTA of nRF52840 with BLE. It is working fine but device takes around 20 seconds to reboot after OTA image data is transferred to nRF52840 via nRF device manager...
Hi, I use nRF52840 DK (SDK 2.5.0), all my attempts to raise examples for "Matter", were not crowned with success (for example projects: Light Bulb, Light switch). Everywhere...
Hi all, We are using nRF Connect Application to discover Bluetooth device implemented on nRF52840 MCU. Company identity data is set within the manufacturer specific data sent...
