Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
HI,
I build project direct_test_mode and empty_app_core and connect to PC softwarre DTM v2.
If build from ncs v1.9.1, it connect ok to show standby. but if build from...
Hi, i wonder how could i send data from a coap_server to a coap_client with thread, for example a temperature data: what are the main functions to declare and use to do so...
Greetings,
We are planning to integrate the use of the internal storage of our nRF52840 MCU using LittleFS so we tried starting out by just opening the sample zephyr/samples...
Dear Team,
Are there any mobile phones / tablet other than Pixel 7 that can be used to test the nrf5340 audio application?
Is Pixel 7 the only phone that was tested...
Hello,
I am using the nRF52832 and am supposed to protect the lines SWDIO, SWDCLK, P0.21/nRESET and P0.30/AIN6 on our board with a TVS diode. With the PESD3V3L4UG, the nRF52832...
I have not been successful to updating the firmware of the Thingy:53 board, and I have tried all methods indicated here: https://developer.nordicsemi.com/nRF_Connect_SDK/doc...
Hello
I am working on an application for the nrf5340 in which I aim to use 2 devices on the QSPI bus. I am on the nrf5340 HW v2.0.0 and NCS v2.1.2.
In looking at the datasheets...
In the nRF910 Hardware Integration document, it says "... it is mandatory to use external pull-down resistors in the size range of 100 kΩ in the COEX interface". In my design...
Hi ,
I have compiled in Heart rat relay into my app; can scan and connect to simulator and garmin HR straps; but fail to connect to polar. My debug log shows...
...
Hi,
I would like to set the publication period sensor model and directly in the code by default (compilation time).
and how can I set by default a publication group address...
Hi We are developing an IoT device that should send its telemetry to an Azure IoT hub. therefore we have choosen the nRF-9160 DK with the azure_iot_hub sample, which works...
Hello
In pm_static.yml I defined a flash partition, intended to save some NV-flags for the application, which should survive OTA/DFU updates.
The project uses BLE for...
python buildprog.py -c both -b debug -d both -p to FALSH the nrf5340 Audio DK (ncs2.2.0, JLink V7.84a ), it reports error.
Based on the error info, searched from the https...
I have a custom board with a BMD-345-A-R module and working with the nrf connect sdk 2.2.0
I have builded and flashed the openthread/cli sample for my nrf52840DK and its...
Hello,
Is it possible to create an overlay file for prj.conf for each build configuration? I see that each build config can optionally have its own separate config file...