Hi
The documentation for the new feature in S110 v8 to change the gatt table size says that to change it the linker configuration needs changing .
This means it is a...
I used to be able to see my development kit in nRFgo studio and flashed S110 onto the chip. Now all I see is: "No boards connected". I am still able to flash programs onto...
Hello,
I have an iOS application communicating with a custom device having a nordic 8001 chip.
They have established a bonded relation. In nRFgo Studio, in Security...
Hi there, thanks for your help in advance!
I have tried the nrf51-ble-ancs-nus sample from github and making it work on a 51822 EK board, i.e., it can receive notifications...
I try to use hcidump, capture CSR dongle on ubuntu14.4.
I can find SDK8.1.1 s110 keypad demo create connection fail.
HCI Event: Command Complete (0x0e) plen 4
LE Set...
I want to experiment with recording observations of the beacons with raspberry pi's.
Is there any precompiled firmware I can install on the nRF51822 smart beacon...
Hello everyone,
I am trying to communicate among 2 NRF24L01+ modules using 2 ATmega16A microcontrollers.
My SPI communication is working fine as I am able to write and...
We are going into sleep mode for the processor. We are using Zephyr and sdk 2.3. We also are keeping a running count of seconds and synching that once a day with a modem....
Hello,
I'm working on a product using the nRF9160 and facing challenges with poor LTE signal strength, leading to significant power drain when the device goes offline. I...
I was pairing using nRF connect app via mobile phone and I noticed that there's a check mark which says "PIN contains letters or symbols":
Is there a pairing method which...
Dear,
I want to use the nPM1300 in my design for general Power Management.
I also want to use a Load Switch to disable some components in my design, but I do need to verify...
Hello,
I'm developing a firmware based on Zigbee CLI sample and enabled DFU of app core and net core via serial.
Now I am setting a custom key for image signing and...
Hi, i've been trying to use gnss function indoors and therefore i need to install an external antenna on my nrf9160dk.
I've read the requirements but i'd like some professional...
i need information on power consumption during advertising and connection in my case its taking too much high current around 1 ma in advertising and 1.5 ma during connection...
I want to implement Buttonless DFU for nrf52833 but unable to get how to implement it. I have gone through some links but that seems to be unclear. How can I implement the...
Hello guys,
I tried to design a pcb antenna for a nrf24l01+, since my company doesnt allow to buy cheap smd breakout board version from china anymore
The pcb stats of...
Hi,
Is there any way to run calibration of the LFCLK at the same time as the RTC is running on the same clock?
At program startup I start the HFCLK, then run this routine...
Hello, I’m developing application for nRF9160 with Zephyr RTOS. Currently I want to add a task watchdog module with a hardware watchdog fallback. I use three threads which...
We created the transceiver side and receiver side sources by reusing the nRF5340 Audio source.
I am creating it in CIS mode using VSCode.
The build ends on the receiver...
Hello,
I am working on a project were two MCU's need to communicate with each other via UART. I am using async UART. I am stuck with this problem where after
PM_DEVICE_ACTION_RESUME...
