Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
When compiling some USB code, my compiler spits out this error:
../../SDK/15.3.0/components/libraries/usbd/class/hid/generic/app_usbd_hid_generic.c: In function 'app_usbd_hid_generic_idle_report_set...
Hi Håkon,
this is my follow-up ticket as requested here:
You can see my setup in the esb_ptx application in https://github.com/stemschmidt/esb-evaluation.git
I am currently...
SDK: nRF Connect SDK v3.3.1 Zephyr: v4.3.99 Board: nrf7002 DK I'm implementing a WebSocket server using the Zephyr HTTP server. The callback looks like: static int ws_connected_cb...
On nRF54L15, MCUboot prints Jumping to the first image slot and then spins forever, never starting the application:
sys_clock_disable() switches the GRTC SYSCOUNTER off...
Hello everyone, I'm working on a long-distance communication application (>50m).
My hardware is nRF52840, PA/LNA: RFX2401C, ceramic antenna: AN9520-245.
I've achieved...
As part of a university project I am trying to read an analog signal and transmit it at the maximum data rate over ESB. But I cant seem to get above 1700kbps without any of...
Hi Nordic team,
We are designing a custom board using an nRF54L15 together with an nRF7002 WLCSP.
Our board has a single 3.3 V power rail. We would like to confirm the...
Hi all,
Can anyone guide me to the right path where I can get how to interface an E INK DISPLAY(ET014TT1) to the NRF52840 DK board or tobwhere I can get the necessary steps...
I'm having strange behaviour after switching to 3.4.0 on nrf9151. Our existing application was working well on 3.2.0 but showed no life with 3.4.0.
To demonstrate, I built...
Hello,
I am having trouble programming the nrf5340 chip using SWD.
Set up:
Custom hardware with the MDBT53V-1M module from Raytac, nrf5340 chip.
SWD, using J-Link...
The nRF7002 Evaluation Kit and the PCA10143 Development Kit both show multiple vias to the ground tab pin 49 but there is no direct connection from the tab to pins 27, 28...
