But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
As far as I understand at the moment only proprietary solutions are available for Mesh DFU and Remote Provisioning.
I assume that Nordic is working on standard solution...
Hello,
After looking at the schematic of the nRF9160 DK and the Thingy:91, I noticed that for the nRF9160 DK there is only one antenna design for LTE, while for the Thingy...
Hello,
When I attempt to download the zip file with title: "nRF ready Smart Remote 3 for nRF52 Series firmware files, version 1.2.1.alpha" from https://www.nordicsemi.com...
Hi Team,
I have a few questions regarding nRF5 SDK and nRF Connect SDK.
I have previously used nRF5 SDK for two years, with and without freeRTOS. We might be making a...
Hello Devzone Community,
I am trying to incorporate Nordic's version of Segger Embedded Studio, SES v5.60 in Zephyr based firmware development for the nRF9160. I've cloned...
Hi, Im trying to get the debugger working in VSCode using the new nrfConnect for VSCode, while following the Youtube series for nRF Connect in VSCode. Im using the following...
When compiling the sample located in samples/subsys/nvs/src/main.c I get the following compile error:
I tried to revert the last commit and manage to compile and run the...
Hi DevZone !
I have a problem with the FDS library. I am using it to store configurations of my nRF52840 that I read every time the chip resets I will write in that only...
Hi,
I have a nRF51822 evaluation board and a nRF52833 DK.
Would it be possible to do Bluetooth direction finding with both of them?
I understand that nRF51822 is not...
Hi,
I am trying to measure my circuit sleep current while connected, through a high value resistor, the problem is while waking up each MIN_CONN_INTERVAL the processor wakes...
It is found that under the same routine in zigBee SDK, the project under pCA10056 folder can run normally without burning the protocol stack, but the project under PCA10059...
We would like to stream data through an l2cap channel from a nRF52840 module to a smartphone. The l2cap connection is initiated by the smartphone, I configured an l2cap tx...
I would like to test some compatibility features using the nrf52833 DK as a Bluetooth 4 transmitter instead of Bluetooth 5 (which it is by default). I do not see an explicit...
hi support team，
i have two questions from customer.
1. Monthly review suggested that Verizon certificate will be on October this year, how about he progress, we have...
