This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hi All,
When working on NCS with SEGGER Embedded Studio Nordic Edition (v5.20b), modify prj.conf will not reflect on rebuild solution.
It seems the IDE doesn't update...
Hello Nordic Team,
i've been evaluating the nRF52833 and i have been having a lot of good success. i have been focused on the SAADC block to ensure it meets my performance...
Hi
Since we need use different C1/C2 (15PF/12PF) for 32.768K XL1/XL2
I check "https://devzone.nordicsemi.com/f/nordic-q-a/37448/asymmetric-crystal-load-capacitors" , and...
Hello,
I'm using nrf connect 1.4.0 and nRF9160 dk
I started testing the aws_iot example. It worked fine with my was set up and was able to see the shadow updated.
...
Hello.
I'm using nrf52833 / SDK 17.0.0
I want to find out SAADC sampling time by using logic analyzer.
However, I still don't know what sampling time is.
In this...
Hi
We are working on the secure DFU. The issue is that the NRF52832 chip resets when switch to the DFU mode. All the GPIOs are turned off during reset. However, one of the...
Hello ,
I am working on nRF52832 using sdk 16 version .How to change the device name dynamically . Actually I want to set the device name via BLE command from the application...
I wonder if the nRF5281x can work in the "LE Advertising Extensions" mode, which seems to be like in Bluetooth 5.0, when data is transmitted by secondary advertising packets...
Hi,
I would like to ask if there is any program which i can use to update firmware Over The Air on nRF51822 chip from Windows command line. I know there is that possibility...
Hi,
I understand that NRF connect source code is unavailable.
However the toolbox Nordic App is too heavy.
Is it possible to get a small Scan Android App source code...
Hello I use nrf52832 and sdk v17.0.
I'm using a battery and I can check whether the battery is charging or not. And I'm going to turn off the Bluetooth function while the...
Hi,
I started a project from scratch and I want to write a simple UART printf solution for debugging for my NRF52832 on PCA10040 DK. I know there's a LOG module but it...
