Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I am trying to learn to use the nrfx API to control the nrf5340.
My installation is the NCS 1.6.0 with SES on OSX
It seems like nrfx most of the API devices are supported...
I'm trying to find a battery for my application and I need to know the max (peak) current draw for the nRF9160. On page 63 of the user guide, the max is 435mA with the specs...
I have a function which writes data to the external flash which is using a FAT file-system further using block device implementation of the SDK. Whenever I am calling the...
Hello,
I am working on nrf5340DK board and with a sample example "central_uart" under ncs->nrf->samples->bluetooth & "peripheral_uart" from ncs v1.5.1. I wanted to send...
Hello,
I am trying to setup test environment using nRF9160DK(PCA10090, 1.0.0)
Dev kit is located in Montreal, Canada.
I started with nRF9160_DK_Getting_Started_Guide...
I am trying to update the bootloader using BLE DFU and it does not seem like the app is launching after the bootloader update.
I currently have an app that works with the...
Hello, I am developing a Zigbee OTA client / server application. My code is based on the example from the 4.1.0 nRF5 SDK. From the example I took only the code related to...
Hi,
What is the the status of android and IOS support of bluetooth 5.0 long range ?
It would be great if you can give us a list of device that support long range (of course...
Hi,
i have some issues with nrfutil, i can't properly perform an OTA DFU over thread, either nrfutil cannot find ncp.hex or it stuck in "thread DFU server is running....
Hi,
I made a project around the peripherial-uart sample with a custom board for a nrf5340 chip.
I work with win10, Toolchain nrf Connect SDK 1.6.1
I can build it and...
Hi,
I'm attempting to develop chip to chip communication where an nRF9160 acts as an I2C master communicating with an nRF52840 acting as an I2C slave.
I got reasonably...
Hello.
Now, I'm trying to combine ble_app_beacon and spis.
I succeeded in building and it generates hex file.
The problem is that the device stops sending BLE data ...
Hi, I am trying to send and receive strings using examples\peripheral\libuarte. I am trying to send a string like this but not receiving it on another board. Also how can...
