But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello! I am having troubles with my custom board using BL5340 from Ezurio. I have tried to flash it via my nrf5340 Audio DK but realized it doesnt support external Flashing...
Hi,
I am trying to set up a secure boot chain on nRF54L15dk with NCS 3.2.3 and an upgradable bootloader .
My intended boot chain is:
B0 / NSIB
S0 / S1 for the second...
Hello,
I would like to implement Device Firmware Update (DFU) over NFC.
Is this supported, and is there any recommended way to implement it? Are there any examples, reference...
I have two nRF52840DK boards that I was working with recently.
PCA10056 3.0.2 2024.33
I flashed one board with a BLE peripheral device code from the nRF connect sample...
Hello,
I'm using dmic module for sampling audio data from microphone. Recently I updated NCS to 3.2.2 and I started observing the following log: "Failed to allocate buffer...
After an update recently with the nRF Connect for VSCode Extension, it's been unable to find where my nRF Connect SDK is located when choosing a build configuration. It used...
Hi,
We are migrating from NRF52840 to NRF54L15 (QFN48).
I am using nrf54l15-qfaa-reference-layout-0_8 as reference but really struggle to understand some design choices...
Environment:
Board: nRF54L15DK ( nrf54l15dk/nrf54l15/ cpuapp )
NCS Version: v3.1.0
Zephyr OS: v3.7.99 (NCS fork) NOTE: I am building this over peripheral uart example...
Hi,
I am developing with NCS 3.0. In my application, I need to use MD5 to calculate a signature. Following Nordic AI's guidance, I enabled CONFIG_PSA_WANT_ALG_MD5=y in prj...
Hi,
I have got nRF54LM20-DK with the nRF7002-EBII add-on. I would like to know is there any recommended camera add-on for this hardware to develop vision based AI solutions...
Hi,
I'm developing a custom board based on nRF9151 (similar to Thingy:91X) and trying to connect to nRF Cloud for location services (A-GNSS, Wi-Fi location, Cellular...
Hi,
I'm working on a project using the Thingy91x for prototyping. I'm using A-GNSS from nRF Cloud and although this is working, I'm not sure of the correct order of commands...
