Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi What is the best way to read cluster attributes periodically in zigbee network coordnicator? any sample code available for one time request or subscription for value change...
Hardware Setup:
nRF52840 DK: Serving as the BLE central device and I2S master.
PCM5102 DAC: Connected to the nRF52840 DK via I2S. The connections are:
LRCK (Pin 30...
Hi ,
For Battery operated devices, we are using NRF52840, and developing the firmware using Segger Embedded studio + NRF SDK. s140nrf52720, nRF5SDK1702d674dde
For our...
Hello,
I'm sorry to ask a maybe stupid question, but I'm a bit lost with the available boot loader options right now.
I want to setup an updatable and secure bootloader...
Hello,
I am using nRF9160DK, nRF SDK 2.8.0 with sysbuild and trying to enable image encryption trough sysbuild Kconfig options. I have set SB_CONFIG_BOOT_ENCRYPTION and...
Hi, After switching to a newer Zephyr version with the hardware model V2 I am struggling to build a BLE sample for the nrf5340 DK. It seems that the netcore image is not built...
Hi guys,
I'm working on a project with a custom board around nrf52832 chip and I'm trying to generate an 8MHz clock signal using the compatible "pwm-clock" on Zephyr.
...
Hi, I have encountered some problems:
hardware: nrf5340-dk
software:Visual Studio Code
ncs:2.5.0
sample: nrf\samples\bluetooth\direction_finding_central & direction_finding_peripheral...
SDK 2.1.0
nRF9160
Hi,
I recently configured a GPIO input in my project with an associated interrupt whenever it detects a high to low transition. The transition is...
Hi,
I am currently extending the NRF Cloud multi service sample, thus I am constantly reflashing my NRF9161DK during development. However today, my device fails to connect...
Hi,
While debugging an issue with reconnecting to our Azure server after the network is lost for some time, I found that azure_iot_hub_connect() returned a non-negative...
I tried to use `-Dmcuboot_DTC_OVERLAY_FILE` to use different mcuboot overlay for different builds but it always use all the overlay files in the folder.
The same way works...
This is a continuation of Case ID: 272157
That case resolved issues I had dynamically changing the device name (and having that new name show up in advertising).
It seemed...
I tested with an nRF52840 dongle, but it seems that nRF Connect for Desktop cannot scan long-range/coded PHY advertisements.
(I used this BLE long range peripheral demo...
