Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi All,
I am new to this community. Apologies if this is getting posted in the wrong part of the community.
I am using nRF52840 as a bare-metal with SDK17.02 along with...
Hello,
which application is the PCA10059 using when I use this board with the nRF Connect app as a BT / USB device? I need to know the command set of the board, because...
Hi,
I can run light_switch on one device as Client, another as Server.
Now I want 1 device to contain both Client model and Server model. Example: when I press on first...
hello
i have two nrf52832 boards with and using sdk 16 i want to use one board as a central and one as a peripheral and achieve a maximum distance of about 30 meters can...
We are facing issues whenever a Bluetooth connection is made between our device (Amazon Locker using nrf52840) and IPhone SE Model.The connection is made successfully but...
Hi,
My development setup:
SDK/SoftDevice: nrf5_SDK_for_Mesh_v5.0.0_src + nRF5_SDK_17.0.2_d674dde + s140nrf52720
HW: nRF52840 DK
I modified the sensor_server example...
Where can I find the presentation material (slides, questions, chat transcript) for the "Get started on your Advanced Wearables project on Hackster.io" webinar
I want to program my Thingy 91 with one of the sample projects. In the programmer App it says the project is invalid for MCUboot DFU, but only when using the Jtag connection...
I want to add DFU to the peripheral_hids_keyboard example from the nRF Connect SDK. I added CONFIG_BOOTLOADER_MCUBOOT=y to the prj.conf and specified a key file.
When building...
I'm using NCS v1.5.0 to create a BLE peripheral using nRF5340-DK.
I set the device name in the prj.conf file using CONFIG_BT_DEVICE_NAME and the name shows up when BLE advertising...
Hi,
I need to implement, say, 100 LPN + proxy and 1 friend + proxy, LPN are measuring devices.
1) How can I request from each, let's say, a temperature value? I want to...
There are two boards, Raspberry PI4 and nRF52840-DK . The task is for the nRF52840-DK on zephyr hci-uart firmware :
https://developer.nordicsemi.com/nRF_Connect_SDK/doc...
