Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Development Software: nRF5 SDK v15.1.0
Windows 10, 64 bit
I'm following the instructions on how to install the micro-ecc library as detailed on the following page:
http...
I am sending task notification from nus_data_handler when in get BLE_NUS_EVT_TX_RDY event
In a seperate task , i am sending ble packets (244bytes) by using ble_nus_data_send...
Hi Team..,
iam using nrf52832 interface with quectel.iam using uart communication..the problem is when i transmit the AT commands nRF to Quectel that is working fine..but...
Hi,
I am trying to flash the hex file through j-link debugger on nrf52810 controller. Flash is done on hex file but not able to execute after done .
why this problem happening...
We plan to use NRF52805 in our existing boards to add BLE functionality. In the PCB guidelines of the NRF52805 there is a notification about the thickness of the PCB being...
SDK: 17.0.0
Softdevice : S140
Example: ble_app_blink
I modify this example to long range adverting mode,and have some questions as follow:
(1) the device can not connect...
Hi there,
I'm working on a Zigbee project and I'm using the nRF5 SDK for Thread and Zigbee v4.1.0. For benchmarking purposes I need to read the number of hops a Zigbee-packet...
Hello,
I am doing on a project which send data from sensors node to thingspeak, and I am now struggling about implement mqtt to publish data to thingspeak.
best regards...
now i use segger development tool ,but can not breakpoint. but log aseggerlso cannot output information.
V4.2.
my colleague's will do
thanks
best regards!
II'm having issues communicating to the MLX90614, datasheet attached. It seems that I have everything set correctly and the TWI Scanner returns addresses and data. My output...
I am looking for a zephyr based sample code to use an external QSPI flash (MACRONIX MX25R6435FZAIL0). The code is run an nRF52840 based custom board
Your help is appreciated...
