Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, We had an issue of our custom build boards were the application firmware could be programmed, but the modem could not be programme because of the error "RootKeyDigest...
have been reviewing the nRF54L15 datasheet but could not find the current consumption specifications for LDO mode. Is it possible to operate the nRF54L15 in LDO mode? If so...
Dear Nordic Semiconductor Support Team,
I am looking for EasyEDA-compatible schematic and PCB reference design files for the nRF54L15-QFAA .
However, I could not find...
Hi, We are in the process of upgrading device firmware (using Nordic nRF9160) from nRF Connect SDK 2.4.2 to nRF Connect SDK 3.4.0 LTS. A number of devices to be upgraded are...
Setup: nRF9151 (LACA A0), production modem firmware 2.0.x, application on NCS 2.9 (modem library). The device has external flash holding both the production modem firmware...
We received the physical part with body marking MPN NRF8001-R2Q32-D , while the manufacturer label indicates MPN NRF8001-R2Q32-R.
Please clarify the difference between these...
Hi,
Our nRF91 fails to register on LTE-M even though it sees suitable cells and PLMNs. Manual PLMN selection fails as well. The network never sends a reject; the modem seems...
Hello I'm developing a project that would communicate with a cellular module using AT-Commands, and voice data using PCM, these cellular modules are always using PCM Short...
Hello,
I'm using an NRF5340 audio broadcast sink, and the nRF Connect SDK version is v3.4.0.
I've added ble connection related definitions to the code to allow the mobile...
Hi,
Test and verify Bluetooth Mesh NLC functionality based on the NCS 3.2.4 and 54L15 by using mesh light ctrl example.
Modify the following configurations in the...
Hi Team,
USB detection is working correctly on the nRF54L20 controller. However, the USB MSC (Mass Storage Class) implementation is not functioning as expected. The device...
Hi,
Setup:
nRF54L15 with NCS v3.4.1.
NSIB with MCUboot as an upgradable bootloader (S0/S1), built with sysbuild and no Partition Manager.
SMP over Bluetooth.
...
Hi, i currently use nrf54L15 and PPK2 in ampere measurement mode.
nrf54l15-DK is PCA10156 1.0.0 2026.37 and PPK 2 is PCA63100 1.1.2 2026.29
For testing purpose i use the...
Hi! We have a device that includes boost converters powered from the battery through the nPM1300.
When these converters are enabled, a short but relatively high current...
