Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
Hello~
The environment： Chip is nrf52820，SDK version is 17.0.2，sd version is s112_7.2.0.
pic1:
Pic1 the APP code that I wrote for this problem. When I only burned...
Hello, I wanted to test the VS Code extension but it failed for the following use case...
In our company, we are building our product-related SDK that uses nRF Connect...
OS in development environment ：Windows10 HARD :(Taiyo Yuden)EBSHSN Series Evaluation Board : Central / Peripherals CPU :(Nordic) nRF52832 / ARMR Cortex-M4F 32 bit processor...
I'm attempting to write to flash memory on our custom board using the nRF52840 using the NVS library in Zephyr 1.5.0. I've ported over the example code from samples/subsys...
Hi everyone,
I try to get manufacturer data with central device.
The peripheral device is normally correctly configured for both advertisement report and scan response...
Hello.
Actually I have two qustions, but they are related with the same challenge.
So, I want to develop application using SDK (libararies and config), but starting from...
Dear ,
Thanks a lot for your time.
We currently have a project using nRF52840 dongle and nRF connect SDK, implementing FATFS and USB MSC SD card examples together.
The...
Hello
When I use ncs1.7.1 52840 + mcuboot + spi + external flash it works well, but when I update ncs to 1.8.0 I can't build it.
I also add CONFIG_MULTITHREADING =y in...
I'm trying to get my nRF9160DK board to connect to nRF Cloud, but I ran into some issues and it's not working. I've followed every step of the nRF9160DK Getting Started Guide...
I have configured the ADC on my nRF52832 to trigger a read based on a PPI timer. I am using EasyDMA to capture 75 samples via double buffering. My PPI timer is configured...
I am migrating my project to C++. Everything in the SDK works so far except NRF_BLE_GATT_DEF(). This returns the error C++ requires a type specifier for all declarations....
I'm using FDS on SDK16.0.0 to store some value, consisting of 12 int32_t values. They are stored correctly, except the first byte. Here is my code used to store :
It prints...
Hello,
is there any way to connect additional sensors using SPI or I2C to the thingy:91?
From the schematics I see test points on the PCB that allow access to the SPI...
