Hello, The nRF9151 hardware design guidelines (power sequence) require VDD_GPIO to be applied at least 6 ms after VDD and ENABLE, after the hardware boot. In our design a...
I'm not sure if I can share the files here, but you can email me at kc6ete at gmail if you want a copy It's a four color print designed for the Snapmaker U1 though it can...
Dear Team,
I have been running two nRF54LM20-DK as Initiator and Reflector for Bluetooth Channel Sounding.
I adjusted the ranging algorithm RAS_Initiator to print Local...
Hi,
I'm trying to find out how people automate current measurements with the PPK2 beyond doing it by hand in the Power Profiler app.
From the threads here it looks like...
During the setup process for nRF Connect SDK v2.4.0, an error occurred preventing the SDK from installing correctly.
The environment details are as follows:
* macOS...
Hello,
I was coming across the I2S timing parameters of the nRF5340 gvien in the data sheet, see below screenshot. The SDOUT setup time is specified only as a minimum value...
Hello,
I am currently trying to get our nRF52 development workflow working in a Docker container. I have been able to compile the firmware in the container and debug it...
Hello,
We are currently evaluating the nrf5340 using the "nrf5340 Audio" development board. Part of the evaluation is to verify if the device can handle 3 TX mono streams...
Hi,
I am trying to implement LESC bonding into my nRF51 application. After a lot of debugging, I assume that pm_lesc_public_key_set() needs to be called before any secure...
Hello everyone,
I am working on a bluetooth camera project using the nRF5340 DK and SDK v.2.2.0. Since the Image data is quite large, I want to store it in a Text file for...
Hello,
Right now I am trying to disable perticular RAM blocks. But I can not find the adresses of the RAM blocks (where block1 starts and ends, where block2 starts and...
Hello, we are using the Bluetooth module BL651 which should be using the nrf52810 chip soldered on our custom board. I followed the documentation installing the appropriate...
Hello, I want to manually perform RSSI measurements, which I am doing as described in the specification of the nRF52840:
Call RXEN task
Call START radio task after READY...
I am trying to easily switch between having CONFIG_LOG enabled and disabled using a makefile, and a file called overlay-log.conf which contains only the line CONFIG_LOG=y...
I would like to configure and use a mesh network based on nRF52833 devices. One device as the proxy gateway connection to a mobile phone or tablet, and up to 40 mesh nodes...
Hello Everyone
I realized that break points cause the main thread to restart if I use ble advertising (verified first in my firmware and then in the official examples: I...
I've been writing this FOTA solution that would work together with an existing server we use together with Onomondo connectors.
And I've been running into this issue when...
One feature I want to implement now is: I have five 52833dk development boards. I want to use one of them to send a packet of data based on ip address protocol. The packet...
