Target device: nRF9151
NCS 3.4.0
Memfault Integrated
FOTA architecture in place with four slots, 2 in internal flash and 2 in external flash
Background COAP updates...
Hello, im trying to create OTA system for nrf54l15 and currently running into issue with the key provisioning
Device: nRF54L15 based custom board ( nrf54l15/nrf54l15...
When I create a new build ciónfiguration in nrf connect I get this Loading and the new configuration is not created itself.
This error is displayed in the VScode.
Could...
While building the program I get this error message: "DT_N_NODELABEL_cpucell_cpuapp_ipc_shm_trace_REG_IDX_0_VAL_ADDRESSU" As far as I can tell, this error message is releated...
Hello,
I have a pin on port 1 of the nrf54l15 that I am bitbanging for a custom tx/rx 2-wire protocol. I have already managed to implement the tx capability and I was hoping...
Hi Nordic team,
I am currently researching Bluetooth Channel Sounding, where I have setup two nrf54LM20-DK as intiaitor and reflector respectively.
I am using NCS 3.3...
Here is an example main.c which you can use as an example to understand corectly how to use the GPIOTE module and toggle the 4 LEDs numbered 1-4 in the nRF52 DK. Forget about...
Hi,
I am trying to implement external flash storage onto my custom board, featuring an nrf9160-SICA-B1 and a Winbound w25q128jv 128Mbit flash chip on SPI3 (I cannot get...
Hello,
we have a problem with modules from raytec MDBT42Q.
We have modules which work with our software as expected, and other ( newer ) that will stuck in Software. ...
I use the following :
-> nRF52840 Dongle / µC on the other side
->Blutooth Low Energy v3.0.1 (desctop version)
I try to read a characterictic after connecting and get...
During an execution of a winbond w25q64jv command (any command) during a BLE_GATTS_EVT_WRITE event the SPI bus goes inactive after the command is sent:
There is apparently...
Hello,
I tried to change the defined UUIDs for the BLE service and characteristics in the LED Button Service example (lbs.h).
E.g.
But the result is somehow...
Hello, I found that my device is more prone to disconnection due to 0x8. And I saw the log and found that most of the disconnected cases were immediately disconnected as soon...
I am using the NRF distance measurements examples between two nRF5340 boards to calculate the distance between them. I want to know how the distance is calculated in phase...
I am attempting to download v10.18.0 of the nRF command line tools for Linux x86 64. However, the .deb file provided is for arm64. Could you please fix this in the nRF command...
While trying to download the latest nrf-commanline-tools for LInux x86_64 I have noticed that the link for the DEB package is wrong: it leads to the arm arch., not the amd64...
Hi.
We've built an app for the nrf5340-based module using the nrf connect 1.6.1 SDK and its out-of-the-box Zephyr/MCU boot loader etc., code base. We build using west, which...
Hallo Team,
We are planning to use nrf5340 for one of our project which requires low energy audio and sensor data transfer. Can you please evaluate if our use case is...
Hi, I am currently developing on nrf9160 DK, and would like to set pins 0.14 and 0.15 as analog inputs to read data from sensors, similar to arduino uno, but not sure how...
