Hello dear fellow developers,
I am solving the problem of how to add another peripheral to the project.
I would like to know a universal procedure for adding any peripheral...
Hi nordic： What is the peak current of NRF9151? The relevant parameter cannot be found in the datasheet, while it is available for NRF9160.
Best Regards
JERMI.JIN
I'm using the nRF52840-DK part number 1490-1072-ND I ordered last week. In both nRF Connect for Desktop and the VS code extension the device wasn't able to detect. Tried two...
Hello, this is probably a very beginner question but I don't know how to configure interrupt for the GPIO headers on the nRF52840 dev kit. I tried to search in this forum...
In the documentation for the secure bootloader, it's mentioned that the provisioning data gets stored in OTP memory for some chips (e.g. nRF5340). Is there a way to know what...
Hi:
I don't receive any messages in the console during any of the exercises in Lesson 3 and Lesson 4 of the nRF Connect SDK Fundamentals.
No errors occurred during the...
Device Overview
We have developed a smart wearable that sends notifications to our mobile application over BLE. Under normal conditions, the device alternates sensor...
Hi, Please have a look and let me know about it.
This board is two layers and i used chip antenna. I would like to ask you, Is this design is correct? How can i plan with...
I have an ongoing issue with using the Keil compiler and the supplied examples.
There has been some email correspondence which is detailed below:-
Hi David,
I have...
Hi
I am reading the sensor data (Irms and Vrms) via I2C protocol and multiplying the read data with 0.000030517578125 to get correct result but i am getting the result as...
Hi:
I use nRF5_SDK_16.0.0_98a08e2\examples\peripheral\usbd_ble_uart_freertos.Error:Unknown USB device (device descriptor request failed).
I use nRF5_SDK_15.2.0_9412b96...
I'm trying to add a SPI driver to the ble_app_uart_c example. For now, I'm just trying to make this driver shoot out a SPI transaction every time I click a button on the dev...
Hi,
I am trying the freertos on my project with nrf52840, sdk14.00, s140_nrf52840_5.0.0-2.alpha_softdevice.
As i can see, there were no example codes for 52840 in the...
hi
I`m debugging the nrf52840 on the pcb I made and have some problem
I know Reset pin is P0.18 of nrf52840 but 3.3V was not measured. So the reset pin does not work....
As mentioned in this article are these vulnerabilities addressed in Nordic Semiconductor's products?
https://thehackernews.com/2020/02/hacking-bluetooth-vulnerabilities...
Hi everyone,
I am using the nRF52840 and SDK 16. Following THIS tutorial was able to create my BLE custom service and see my service with the custom UUID.
The problem...
Need to design a simle RSSI based tracker using nrF52810. Due to current global issue, cannot order hardware at the moment.
So meantime I am planning to learn all software...
Hello,
Originally, the Zigbee light_control examples ships with a bulb that can call the zb_bdb_finding_binding_target() function , and a light switch that calls zb_bdb_finding_binding_initiator...
I searched in this forum about softdevice_fault_handler errors, but could not find the cause of my problem. I need to obtain more information for a softdevice_fault_handler...
Hi,
Can you please let know a way to run two processes two process simultaneously on the two cores of nRF5340 board. An example project would be of great help !
Thanks...
