Hi,
I am trying to make the nrf52833 into an Auracast broadcast receiver (for a broadcast from my phone).
I am using bindings to the softdevice controller ( https://github...
Hi Nordic team,
I tried to view logs from my custom nRF54L15-based MCU using J-Link RTT Viewer, but it's (printk) not working. The same prj.conf configuration was previously...
Hello Nordic Support Team,
I am working on an nRF52-based project on a custom PCB using the E73-2G4M08S1C devboard ( https://www.cdebyte.com/products/E73-2G4M08S1C ).
...
Hi there!
We're designing a system with ~1000 battery-powered moveable devices distributed across a large rectangular area (approx 200m x 1000m) . Each device collects approximately...
I have DevKit board PCA10156 0.9.2. I only see HW files for 0.9.1 on the Dev Kit main page: https://www.nordicsemi.com/Products/Development-hardware/nRF54L15-DK/Hardware-files...
Hi everyone,
I’ve been using the Power Profiler Kit II (PPK2) and was wondering if the firmware source code is publicly available, or if there are any plans to publish it...
Hi everyone,
I'm trying to get the LIS2DH12 sensor sample working with the nRF54L15-DK , but I'm running into an issue where the device doesn't seem to initialize properly...
I am in the process of adding central functionality to ble_app_buttonless_dfu on a PCA10056.
When I call nrf_ble_scan_filter_set, the resulting builds debugging is broken...
Hi, I want to use the ADC peripheral (SKD16) and I am looking for the most energy-efficient way of doing this. I design a prototype that will be based on nRF52840 IC and will...
For a temperature sensing application, I am trying to implement a TWI interface with a TMP116 temperature sensor. I am using Keil uVision 5 to write the program. I have been...
I am attempting to port a BLE application to the nRF52840. The original application used a standard HCI serial interface so I am trying to adapt that to use the Nordic SoftDevice...
Calling the lte_lc_connect() function eventually leads to the code breaking on:
fault_s.S line 104
#elif defined(CONFIG_ARMV7_M_ARMV8_M_MAINLINE) /* force unlock interrupts...
Hi I am using NRF52 board to interface analog sensor and this board further transmit the data ro sink node. I am using saadc example but unable to get callback or my interrupt...
We have a set of custom boards I am working on debugging. I was able to get our software onto the device via nrf jprog tool by uploading a merged hex file (with SD + bootloader...
Hello,
I would like to turn off the logging to UART0 completely on my custom device.
In the past, I have been able to do this using various config options and reduce the...
Hi!
I am currently playing around with the example combining uart and MQTT from this thread , and it seems to work okay. But when i try to send more than 10 characters over...
My end goal for development is something like the following.
Master sends 0x00 slave sends back 13 bytes of data. Master sends 0x01 slave sends back one byte of data....
Hi,
I need to use the cryptocell in a project with a preemptive OS. Are there any relevant code examples available, or at least some general guidelines and precautions ...
Hello,
I would like to implement the network time synchronization from the Openthread API to the existing simple_coap_client example from the Thread and Zigbee SDK. I'm...
Can we increase the packet size in Nrf52 Beacon example ? I want to send UUID=16 Bytes + Major=4 Bytes, Minor= 4 Bytes + RSSI= 1 Byte i.e Total = 25 Bytes. I am using SDK13...
