Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
The chip I am using is 54l15, and the NCS version is 2.8.0
I used the peripheral_uart example for modification and got my own program, but I forgot which time this problem...
Hi Nordic
Asking this question to Nordic AI (right-down window), below was the answer.
The nRF9160 is a cellular IoT device, and its MTU size depends on the protocol...
I am programming a RAK4631 Board, which is of course based on the nrf52840 SoC. The BaseLine Device tree has no detail in the ADC Node so I have created an overlay. The RAK4631...
Toolchain v2.70, SDK v2.7.0, VS Code, Windows
The design has an eSIM and a regular SIM, with a switch driven by a GPIO line. We default to the regular SIM, but if the library...
Hello,
How can I check which crystal oscillator is configured for the nRF52832 DK from the firmware side? Is there a specific configuration file or parameter that defines...
Hello,
I have a Python script that analyses some sensor data. If a condition is met I want to send a trigger via ESB to a peripheral board (ESB chosen for its low latency...
Hello, I'm having issues when building the peripheral_nfc_pairing and central_nfc_pairing samples from ncs 2.2.0 in VSCode. I've build before and haven't gotten any errors...
Hi,
I’m currently working on a Zephyr project using the nRF Connect SDK, and I am looking for a way to setup the toolchain for my terminal emulator (specifically using zsh...
Hi
I'm new on zephyr and nRF9160.
In the nrfx source are lots of NRFX_ASSERT() macros.
This macro checks a condition and thrown a exception.
Normaly we use asserts...
Hello everyone,
We are using the NUS service to transmit some data. To comply with certain CEM tests and regulations, we need the ability to configure BLE to publish on...
Hi,
I'm working with the nRF21540 Development Bundle (DB) , which includes the nRF21540 DK and nRF21540 EK . I need to use the FEM module with the GPIO+SPI interface to...
As title says, I have a clean install of Xubuntu 23.10, latest nrfutil and toolchain-manager package
My shell is zsh, however "nrfutil toolchain-manager launch --shell zsh...