Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I used the nRF52840 SDK 15.3.0 dfu secure_bootloader uart example to develop a custom bootloader. I have checked that my application file is correct by trying it without the...
MCU: nRF52840
IDE: Keil uVision 5.17
SDK: 15.2.0
Board: Custom
OS: FreeRTOS
Using MicroLIB
Hello,
I am currently working on a FreeRTOS project that leverages...
Hi,
Based on the below extract:
"Because older devices that don’t support Bluetooth 5 will not be able to discover extended advertisements, an advertising set with legacy...
Hi, I am currently using the PPK2 for current measurements.
According to the datasheet, the PPK2 supports a maximum source voltage of 5 volts. However, my device requires...
Hello
we are certifiying our product by ISO 13849-1 which includes the Nordic nRF52832, among more information I would like to start with the following questions
1. where...
Dear nordic support
We're in the concept phase of a product that implements cellular cloud connectivity.
We already implemented a "blueprint" ESW which provides supporting...
Hi,
I am planning to create an ultrasonic library (based on ch201) because I can't find any library for it. So I am porting code from ch201 development kit to nrf52 custom...
Hi there,
I have a Thingy:91 board and I would like to enable the accelerometer data to be sent to nRF cloud when using the Asset tracker v2 application. I saw that it is...
Good afternoon,
I'm trying to understand how the RTC works on the nRF52.
The RTC can run when HFCLK is OFF and PCLK16M is not available
Section 25.5 describes the TICK...
It appears that KConfig is uable to find any compilers for native_posix with VS Code on windows 10 after installing all recommended packages and prerequisites during SDK install...
Hello,
I am using LwM2M library in my project and I want to check what version I am using of LwM2M carrier library. Please correct me if I am wrong, is according to below...
I am creating software for a proof-of-concept device using the nRF52840 Dev Kit and nRF Connect for VS Code.
I started a few weeks ago with the Nordic UART Service code...
With Zephyr, I am using BLE Stack sample (rpc-host) on net core and peripheral_uart on app core. I changed the uart pins on from the standard dvk configuration on devicetree...
Hi
I was wondering why there there seems to be no information about profiling of the LC3 codec by T2.
Only information I found is from Karl's answer here :
The rule...
