I'm trying to use the ADC and internal reference to measure battery voltage on the nrf51422, while S210 is enabled.
From the example nrf51-ble-app-temp-master, I found...
I have Nokia Lumia 630 and it works well with nRF51822-EK but only with SDK nrf51822_v5.1.0.36092 and SoftDevice 6.0.0. Now I decided to try DFU OTA. I programmed bootloader...
Hello,
I found that there is a multiprotocol demo in folder Board\nrf6310\s110\experimental\ble_app_multiactivity_beacon,then I found it can implement concurrent connected...
Dear Sir
We got the problem on DFU upload firmware, it always failed in second DFU . We must unpair the device at iOS setting panel. Before next DFU.
Here is the log data...
Hi All,
My requirement is to read the data from nRF51822 device that is connected to a bluetooth and bluetooth is connected to a system using a .Net application.
I have...
Hi everyone,
I'm using the nRF51822 (pca10000 Dongle + pca10005).
My plan is to send one byte over the radio.
I tried to use the SDK-Example as a template but it's...
Dear,
I want to use the nPM1300 in my design for general Power Management.
I also want to use a Load Switch to disable some components in my design, but I do need to verify...
Hello,
I'm developing a firmware based on Zigbee CLI sample and enabled DFU of app core and net core via serial.
Now I am setting a custom key for image signing and...
Hi, i've been trying to use gnss function indoors and therefore i need to install an external antenna on my nrf9160dk.
I've read the requirements but i'd like some professional...
i need information on power consumption during advertising and connection in my case its taking too much high current around 1 ma in advertising and 1.5 ma during connection...
I want to implement Buttonless DFU for nrf52833 but unable to get how to implement it. I have gone through some links but that seems to be unclear. How can I implement the...
Hello guys,
I tried to design a pcb antenna for a nrf24l01+, since my company doesnt allow to buy cheap smd breakout board version from china anymore
The pcb stats of...
Hi,
Is there any way to run calibration of the LFCLK at the same time as the RTC is running on the same clock?
At program startup I start the HFCLK, then run this routine...
Hello, I’m developing application for nRF9160 with Zephyr RTOS. Currently I want to add a task watchdog module with a hardware watchdog fallback. I use three threads which...
We created the transceiver side and receiver side sources by reusing the nRF5340 Audio source.
I am creating it in CIS mode using VSCode.
The build ends on the receiver...
Hello,
I am working on a project were two MCU's need to communicate with each other via UART. I am using async UART. I am stuck with this problem where after
PM_DEVICE_ACTION_RESUME...
I'm currently working on a firmware for a device where the app core and net core need to share some sensor and configuration data. I want to use the rpmsg_service for that...
Hi Nordic Community,
I'm currently working on FCC certification for a project and need to enable BLE Direct Test Mode (DTM). I'm using the `hci_uart` sample and have activated...
Hi,
I have design my own board using a µC to talk to the nrf9160 in at command. My code is working with the devboard, but I don't understand how to flash the AT command...
Hi,
I am using nRF52832 board with the SDK version nRF5_SDK_15.3.0 and soft device S132.
I have implemented the POF(power fail comparator) to generate event when the event...
